Power-On Message; Transceiver Lock - Kenwood TH-D7A Instruction Manual

POWER-ON MESSAGE

Each time you switch the transceiver ON, "HELLO !!"
1
appears and stays for approximately 1 second. You can
2
program your favorite message in place of the factory
default.
3
4
1 Press [MENU] to enter Menu mode.
5
2 Press [1], [1], [1] to select "1–1–1 (PWR ON MSG)".
6
• The display for entering a message appears; the first
digit blinks.
7
8
9
10
11
12
3 Press [UP]/ [DWN] to select a character.
13
• You can enter alphanumeric characters plus special
14
ASCII characters.
15
4 Press [OK].
16
• The cursor moves to the next digit.
17
5 Repeat steps 3 and 4 to enter up to 8 digits.
18
• Pressing [OK] after selecting the 8th digit completes the
19
programming.
20 • To complete programming the message after entering
less than 8 digits, press [OK] twice.
21
• Each press of [ESC] causes the cursor to move
22
backward.
23
• Pressing [A/B] deletes the digit at which the cursor is
blinking.
50
6 Press [MENU] to exit Menu mode.
You can also use the keypad to enter alphanumeric
characters in step 3. For example, each press of [TNC]
switches entry as A, B, C, a, b, c, then 2. Press [DUAL]
to switch 0 and space. Press [ENT] to switch among the
special ASCII characters.

TRANSCEIVER LOCK

This function prevents accidental changes, or
unauthorized individuals from changing the transceiver
settings.
Press [F] (1 s) to switch the function ON (or OFF).
• A key icon appears when the function is ON.
You may want to use the Tuning control or [UP]/ [DWN]
in Transceiver Lock mode. Access Menu 1–5–4 (TUNE
ENABLE) and select "ON".
PACKET96BCONDUP
STA CON
9
7
5