Connecting The Transporter With The Hf Transceiver - Kenwood TH-D7A Instruction Manual

CONNECTING THE TRANSPORTER WITH THE HF
TRANSCEIVER
1
You can use the optional cables (PG-4R) to connect the
2
Transporter with the HF transceiver. For these cables,
3
contact your authorized KENWOOD dealer.
4
Note:
Switch OFF both the Transporter and HF transceiver before making
5
the connection.
6
The Transporter automatically transmits its call sign in Morse at
regular intervals because of the legal requirement; therefore, transmit
7
sidetone must be output from the HF transceiver. On TS-570D or
TS-570S, do not select "OFF" in Menu 21. On TS-870S, use the
8
MONI control to adjust the volume of sidetone.
9
When the Transporter is too close to the HF transceiver, unwanted
feedback may cause malfunction.
10
Do not share a regulated power supply between the Transporter and
11
the HF transceiver. Unwanted feedback may cause malfunction.
12
13
14
15
16
17
18
19
20
21
22
23
84
2.5 mm (1/10")
3.5 mm (1/8")
You need not worry about
which end goes to which side
3.5 mm (1/8")
2-conductor plug
You may install appropriate noise
filters at the shown positions to
prevent unwanted feedback from
causing malfunction.
I/O
unit
I/O unit
HF transceiver
COM connector
EXT SP jack
MIC connector