Servicing Standard Mortise Trim Parts
S
ERVICING THE CORE
Removing the core
Reinstalling
the core
Caution
5–14
Perform these steps for EV and FV function locks only.
Note:
For a description of lock functions, see
1. Insert the control key into the core and rotate the key 15 degrees to
the right.
2. Remove the core from the cylinder.
Cylinder
Core
Control key
Figure 5.15 Removing and reinstalling the core
1. Insert the control key into the core and rotate the key 15 degrees to
the right.
2. With the control key in the core, insert the core into the cylinder.
3. Rotate the control key 15 degrees to the left and withdraw the key.
The control key can be used to remove cores and to access doors.
Provide adequate security for the control key.
4. Reinstall the following parts:
escutcheons
(page
levers
(page
5–2).
page
Inside of door
5–6)
B.A.S.I.S. V Service Manual
2–2.