Connections - Sony CDX-GT72W Service Manual

CDX-GT72W/GT720/GT770
• CDX-GT770
Location of controls and basic operations
Main unit
PUSH ENTER / SOUND / MENU
MODE
SHUF
LIST
BACK
DSPL
SOURCE
Card remote commander
RM-X156
OFF ATT
SOURCE SOUND MODE
MENU LIST
+
ENTER
–
DSPL SCRL
REP SHUF
1 2 3
PAUSE
4 5 6
+
VOL
–
6

• CONNECTIONS

• CDX-GT72W
A
SUB OUT (MONO)
B
BUS AUDIO IN
BUS CONTROL IN
BUS AUDIO IN
Source selector*
Selector de fuente*
XA-C40
BUS CONTROL IN
6
SCRL
OFF
AUX
This section contains instructions on the location
of controls and basic operations. For details, see
the respective pages.
For optional device (CD/MD changer, etc.)
operation, see "Using optional equipment" on
page 11.
The corresponding buttons on the card remote
commander control the same functions as those
on the unit.
LIST/BACK control
Push (LIST) up: to list up (Radio).
Push (BACK) down: return to the previous
display.
MODE button page 8
1
To select the radio band (FM/AM)* .
SHUF (shuffle) button page 8
Multi way encoder
Rotate to: Adjust the volume/select a menu
item.
Push up/down/left/right to: Select a menu
item.
Press to: Enter sound setting/apply a setting.
Press and hold to: Enter menu.
AUDIO OUT
FRONT
AUDIO OUT
REAR
* not supplied
no suministrado
CD:
Push up/down to:
– Skip albums (push)* 2 .
– Skip albums continuously (push and
hold)* 2 .
Push left/right to:
– Skip tracks (push).
– Skip tracks continuously (push, then push
again within about 2 seconds and hold).
– Reverse/fast-forward a track (push and
hold).
Radio:
Push up/down to:
– Receive stored station.
Push left/right to:
– Tune in stations automatically (push).
– Find a station manually (push and hold).
Disc slot page 5
To insert the disc.
Display window
(eject)/ANGLE button page 5
To eject the disc/slide down the front panel
(press); angle the front panel in 3 positions
(press and hold).
(front panel release) button page 5
SOURCE button
To power on; change the source (Radio/CD/
1
AUX)* .
DSPL (display) button page 8
To change display items.
RESET button (Location behind the front
panel) page 4
Frequency select switch (located on the
bottom of the unit)
See "Frequency select switch" in the
supplied installation/connections manual.
SCRL (scroll) button
To scroll the display item.
OFF button
To power off; stop the source.
AUX input jack page 11
To connect a portable audio device.
Receptor for the card remote
commander
Connection example
Notes ( - A )
• Be sure to connect the ground (earth) lead before connecting
the amplifier.
• The alarm will only sound if the built-in amplifier is used.
Tip ( - B - )
For connecting two or more CD/MD changers, the source
selector XA-C40 (not supplied) is necessary.
Ejemplo de conexiones
Notas ( - A )
• Asegúrese de conectar primero el cable de conexión a masa
antes de realizar la conexión del amplificador.
• La alarma sonará únicamente si se utiliza el amplificador
incorporado.
Sugerencia ( - B - )
Si desea conectar dos o más cambiadores de CD/MD,
necesitará el selector de fuente XA-C40 (no suministrado).
The following buttons on the card remote
commander have also different buttons/functions
from the unit. Remove the insulation film before
use (page 4).
MENU button
To enter menu.
ENTER button
To apply a setting.
/ (SEEK –/+) buttons
The same as pushing the multi way encoder
left/right on the unit.
Setup, sound setting, etc., can be operated by
.
VOL (volume) +/– button
To adjust volume.
ATT (attenuate) button
To attenuate the sound. To cancel, press
again.
SOUND button
To enter sound setting.
LIST button
To list up.
/ (+/–) buttons
The same as pushing the multi way encoder
up/down on the unit.
Setup, sound setting, etc., can be operated by
.
Number buttons
CD:
: REP page 8
: SHUF page 8
: PAUSE
To pause playback. To cancel, press
again.
Radio:
To receive stored stations (press); store
stations (press and hold).
*1 In the case of a CD/MD changer being connected;
when is pressed, the connected device
("MD") will appear in the display, depending on
which device is connected. Furthermore, if
is pressed, you can switch the changer.
*2 When an MP3/WMA/AAC is played.
Note
If the unit is turned off and the display disappears, it
cannot be operated with the card remote commander
unless on the unit is pressed, or a disc is
inserted to activate the unit first.
7