Toshiba e-STUDIO163 Service Handbook page 196

18)Image dislocation in feeding direction
Defective area
Scanner/Printer adjust-
ment
Registration roller
Registration clutch
Pre-registration guide
Feed system
e-STUDIO163/166/203/206
TROUBLESHOOTING
Fig. 5-18
Step Check items
1 Have the printed images been dislo-
cated in the same manner?
2 Is the registration roller dirty, or the
spring detached?
3 Is the registration roller working prop-
erly?
4 Is the registration clutch working
properly?
5 Is the pre-registration guide installed
properly?
6 Is the aligning amount proper?
Adjust the position of the leading
edge of paper in the Adjustment
Mode.
Clean the registration roller with alco-
hol.
Securely attach the springs.
Adjust or replace the gears if they are
not engaged properly.
Check the registration clutch, and
replace them if necessary.
Install the guide properly.
Adjust the aligning amount.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
5 - 38
Prescription