The Usb Connector - Kenwood 50 MHZ ALL MODE TRANSCEIVER TS-590S User Manual

8.2.2 Controlling TS-590S from a PC using the USB Connector
The microphone connected to the TS-590S and the transceiver's built-in speaker are used.
Virtual COM port
Control signal
Audio signal
8.2.3 Controlling TS-590S from a PC using the COM and ACC2
connectors (microphone and speaker connected to the PC to
be used)
The microphone and speaker connected to a PC are used. The ACC2 connector is used for input/
output of the TS-590S's audio signal.
Control signal
Audio signal
Caution: To use the ACC2 connector for input/output of the audio signal, ARUA-10 is not required.
8.2.4 Controlling TS-590S from a PC using the USB connector
(microphone and speaker connected to the PC to be used)
The microphone and speaker connected to the PC are used. The USB connector is used for input/
output of the TS-590S's audio signal.
Virtual COM port
Control signal
Audio signal standard driver
and ARUA-10
TS-590S
PC
Software Hardware
driver and
ARCP-590
-
PC
Software Hardware
ARCP-590
The microphone
and speaker
-
connected to the
PC
PC
Software Hardware
driver and
ARCP-590
The microphone
Windows
and speaker
connected to a
PC
8 EXPANSIVE APPLICATION SOFTWARE
Type of
Connection
- USB cable
- No connection
Type of
Connection
- RS-232C cable
Home-made
audio cable
Type of
Connection
-
USB cable
TS-590S
Hardware
* Connected to the USB connector
The microphone connected to the
TS-590S and the transceiver's built-in
speaker
TS-590S
Hardware
* Connected to the COM connector
* Connected to the ACC2 connector
TS-590S
Hardware
* Connected to the USB connector
CONTENTS
53