THE BOSE PRODUCT, AND SHALL NOT BE REPRODUCED OR USED FOR ANY OTHER PURPOSE. WARRANTY The Bose SoundTouch Wireless Pedestal is covered by a 1-year limited warranty. PART LIST NOTES 1. The individual parts located on the PCBs are listed in the Electrical Part List.
With the addition of the SoundTouch pedestal to the Wave ® music system, you can listen to Wi-Fi music at the touch of a button. Use the free SoundTouch app to set up and control your system. System features •...
Page 4
® music install the SoundTouch app on a computer system III. that is on your home network. 1. Place the SoundTouch pedestal on a flat, Next, you will use the app to connect the stable surface. Wave ® SoundTouch music system to the network.
PACKAGING PART LIST SoundTouch Wireless Pedestal (refer to Figure 1) Item Description Part Number Note Number CARTON, D/C, 200B, 17.44X11.88X2.13 363719-0010 PACKING, TRAY, MP, TOP 363720-0010 BAG, FOAM, 16.5 X 11.5 X .03 310911 LABEL, WAFER, SEALING, 1.5” DIA, CLEAR 322267-0010 ...
3. You can now replace the base (2). run to the Wi-Fi Module PCB (7). Note: The Service replacement enclosure base is supplied with the Bose Link cable, 2.3 Remove the two screws that secure the rear panel I/O label and feet attached as a I/O PCB assembly to the base.
TeraTerm terminal emulator (Download at http://sourceforge.jp/projects/ttssh2/) 1.3 Connect the SoundTouch wireless pedestal to the computer. TAP commands are sent to the SoundTouch • Connect the RS-232 to TTL converter to wireless pedestal by connecting to the the COM port on the PC.
32, TAP Command Setup. Connect the SoundTouch wireless pedestal ® to the Wave Music system III using the Bose link cable on the pedestal. Connect the Wave ® Music system III to AC power. 1. Connecting to a Wi-Fi Router 1.1 Enter the following TAP command for...
3.2 Provide the customer instructions for under Network Adapters. You should see the reconnecting their system to their Wi-Fi SoundTouch Wi-Fi adapter as an adapter. network. Download the instructional sheet on the product’s repair information page. Directions: On your computer, click on Start and navigate to Run.
1. Setting the Serial Number the response. 1.1 Connect the SoundTouch wireless 3.4 Return to CLI prompt by entering the pedestal to a computer as shown in the TAP command “rm /mnt/nv/local_services” and command setup procedure on pages 31 - <enter>.
Then type “e” and <enter>. The command line spotty login: should be dis- 2.2 Enter location of demo URL played “sys configuration DemoAudioURL http:// on the computer. worldwide.bose.com/downloads/assets/ audio/take5.mp3” 5.2 Enter TAP command “root” and <enter>. The command line should be 2.3 Enable Demo root@spotty:root#.
Page 37
• Plug the thumb drive into the SoundTouch wireless pedestal. • Connect the unit to power by connecting the Bose link cable to the back of the Wave Music System III while holding down the reset button on the back of the Wi-Fi adapter.
SERVICE MANUAL REVISION HISTORY Date Revision Description of Change Change Driven Pages Level Affected 11/13 Document released at revision 00. Service manual release...
Page 39
SPECIFICATIONS AND FEATURES SUBJECT TO CHANGE WITHOUT NOTICE Bose Corporation The Mountain Framingham Massachusetts USA 01701 P/N: 369881-SM Rev. 00; 11/2013 (H) http://serviceops.bose.com...
Need help?
Do you have a question about the SoundTouch and is the answer not in the manual?
Questions and answers