Bose SoundTouch Controller Quick Start Guide

Setup

To set up the SoundTouch^™ controller, you need:

• SoundTouch^™ app installed on your computer.
• SoundTouch^™ system connected to your home network.

Note: The controller operates the SoundTouch^™ system that you select in the app. To connect to another system, refer to the help system in the app.

Step 1

1. On your computer, launch the SoundTouch^™ app.
2. Click EXPLORE > SETTINGS > Systems.
3. Select the system to connect to the controller.
4. Click CONNECT SOUNDTOUCH^™ CONTROLLER.

Step 2

1. When prompted by the app, install the batteries into the controller.
   The controller turns on.
   The screen and presets illuminate.
   The screen shows system messages and Now Playing information.
2. Follow the instructions in the app.

Use only alkaline batteries.

Step 3

Use the controller to operate your system.

• Press a preset to play it. Press and hold a preset to personalize it.
• Move your finger around the Presets ring to view presets.
• Turn the volume ring to adjust the volume.
• Touch or to skip through content.
• Press and hold the screen to turn the SoundTouch^™ system on and off.
• Press the screen to play or pause music.
• Touch the SoundTouch^™ icon to disconnect the controller from a system. To connect to another system, refer to the help system in the app.

Note: If the controller is in power saving mode, wave your hand within6 in. (15 cm) above the screen to turn it on.

Mounting the controller on a wall

Wallboard (anchors and screws supplied)

1. Use a 3/16 in. (5 mm) drill bit to drill two holes into 3/8 in. (10 mm) or thicker wallboard. (Use the bracket as a template.)
2. Insert the anchors into the holes and tap lightly to secure.
3. Align the bracket (tab at top) to the anchors. Tighten the screws into the holes.
4. Align the latch to the bracket's tab. Attach the controller.

Wood

1. Purchase two #6x1.0 in. (25.4 mm) flat-head wood screws.
2. Use a 7/64 in. (2.778 mm) drill bit to drill 2 holes into 3/4 in. (19 mm) or thicker wood. (Use the bracket as a template.)
3. Align the bracket (tab at top) to the holes. Tighten the screws into the holes.
4. Align the latch to the bracket's tab. Attach the controller.