Presetting Radio Stations Manually; Receiving Preset Stations; Receiving Preset Stations In Order - Kenwood VR-50RS Instruction Manual

Listening to radio broadcasts

Presetting radio stations manually

1
Tune to the station you want to store.
2
Press the MEMORY key while receiving the station.
Blinks for 20 seconds
Proceed to step 3 within 20 seconds.
(If more than 20 seconds elapse, press the MEMORY key again).
3
Use the MULTI CONTROL knob or MULTI CONTROL % / fi keys
to select one of the station presets (1 – 40).
4
Press the MEMORY key again to confirm the setting.
• Repeat steps 1, 2, 3, and 4 to store as many stations as
necessary.
• If you store a station at a previously used preset, the previous station
will be replaced by the new one.

Receiving preset stations

1
Press the TUNER key to select tuner as the source.
2
Enter the number of the preset station you want to receive
(up to "40").
Press the Numeric keys in the following order:
For "15", press ................................ 0, 5
For "20", press ................................ 0, 0, )
• If you make a mistake entering a two digit number, press the +10
key repeatedly to return to the original display and start again.
22 EN

Receiving preset stations in order

1
Press the TUNER key to select tuner as the source.
2
Use the P.CALL 4¥¢ keys to select the desired station.
• Each time you press the key, another preset station is received in
order.
Pressing the P.CALL ¢ does the following:
Pressing the P.CALL 4 does the following:
Holding down the P.CALL ¢ or 4 key, lets you skip through
the presets, receiving each preset station at 0.5 second intervals.
(P.CALL)