Compaq Prolinea Family Maintenance & Serice Manual page 33

For assistance in the removal and replacement of a particular subassembly,
see Chapter 5, "Removal and Replacement Procedures."
Table 2-2. Processor Test Error Codes
===========================================================================
Error
Code Description
===========================================================================
101 - xx CPU test failed
---------------------------------------------------------------------------
102 - xx Coprocessor or Weitek
Error
---------------------------------------------------------------------------
103 - xx DMA page registers
test failed
104 - xx Interrupt controller
master test failed
105 - xx Port 61 error
106 - xx Keyboard controller
self-test failed
---------------------------------------------------------------------------
107 - xx CMOS RAM test failed
108 - xx CMOS interrupt test
failed
109 - xx CMOS clock test
failed
---------------------------------------------------------------------------
110 - xx Programmable timer
load data test failed
113 - xx Protected mode test
failed
---------------------------------------------------------------------------
114 - 01 Speaker test failed
===========================================================================
Table 2-3. Memory Test Error Codes
===========================================================================
Error
Code Description
===========================================================================
200 - xx Memory machine ID
test failed
202 - xx Memory system ROM
checksum failed
---------------------------------------------------------------------------
203 - xx Write/Read test
Recommended Action
Replace the system board and retest.
1. Run the Configuration and
Diagnostics Utilities.
2. Replace the coprocessor and retest.
3. Replace the processor
(if applicable) and retest.
Replace the system board and retest.
The following steps apply to 107 - xx
through 109 - xx:
1. Replace the battery/clock module and
retest.
2. Replace the system board and retest.
Replace the system board and retest.
1. Check system configuration.
2. Verify cable connections to speaker.
3. Replace the system board and retest.
Recommended Action
The following steps apply to 200 - xx and
202 - xx:
1. Replace the system ROM and retest.
2. Replace the system board and retest.
The following steps apply to 203 - xx