Tnc Commands List - Kenwood TH-D72A Instruction Manual

TNC COMMANDS LIST

The commands supported by the built-in TNC are listed below. You must enter a space between a command name (or
short-form) and a parameter, or between two parameters; ex. AU OFF, BEACON EVERY 18.
Command Name Short
AUTOLF
AXDELAY
AXHANG
BEACON
BTEXT
CALIBRAT
CHECK
CMSG
CMSGDISC CMSGD
CONMODE CONM
CONNECT
CONOK CONO
CONSTAMP CONS
CONV
CONVERSE
CPACTIME
CR
DAYSTAMP DAYS
DAYTIME
DAYUSA DAYU
DIGIPEAT
DISCONNE
When ON, sends a line feed (LF) to the computer after each
AU
carriage return (CR).
Specifies the delay time to be added to TXDELAY between
AXD PTT ON and start of transmission. The unit of the parameter
is 10 milliseconds.
Specifies the voice repeater hang time. The unit of the
AXH
parameter is 100 milliseconds.
If set to EVERY, sends a beacon packet at intervals of the
specified period (n). If set to AFTER, sends a beacon packet
B
only once after the specified period (n). The unit of n is
10 seconds.
Specifies the content of the data portion of a beacon packet.
BT
Sends a space/mark square wave (50/50 ratio). Enter Q to
CAL
exit Calibrate mode and restore the Command mode.
Specifies the interval from signal drop-out until execution of
CH
disconnection. The unit of the parameter is 10 seconds.
When a connection is made, the message is
CMS
automatically transmitted.
When a connection is made, it automatically
disconnects.
With NOMODE set to OFF, causes the TNC to automatically
enter Converse or Transparent mode when connection is
completed.
Sends a connect request. Call1 is the call sign of the station
C to be connected to. Call2 to call8 are call signs of stations to
be digipeated through.
When ON, accepts a connect request and returns a UA
packet. When OFF, rejects a connect request and returns a
DM packet.
When ON, displays the current date and time when
connection is completed. The correct date and time must be
set using DAYTIME.
Causes the TNC to enter Converse mode. Press [Ctrl]+[C]
or K to restore the Command mode.
When ON and in Converse mode, sends a packet at
CP
intervals of the period determined by PACTIME.
When ON, appends a carriage return (CR) to all packets to
CR
be sent.
When ON, pressing [Ctrl]+[T] in Converse mode causes the
TNC to send date data in addition to time data.
Sets the current date and time. Enter YYMMDDhhmmss.
DA
Sets 00 as the second if entry of the second is omitted.
When ON, displays the date like MM/DD/YY. When OFF,
displays the date like DD-MM-YY.
DIG When ON, allows the TNC to function as a digipeater.
D Sends a disconnect request.
Description
PACKET – 2
Parameter Default
ON/ OFF ON
0 ~ 120
0 ~ 250
EVERY/ AFTER n
EVERY 0
(n = 0 ~ 250)
0 ~ 159 characters
0 ~ 250 30
ON/ OFF OFF
ON/ OFF OFF
Concvers/ Trans Concvers
Call1 (VIA call2,
call3, ... call8)
ON/ OFF ON
ON/ OFF OFF
ON/ OFF OFF
ON/ OFF ON
ON/ OFF OFF
ON/ OFF ON
ON/ OFF ON
0
0