Naming A Memory Group; Memory Group Link; Clearing A Memory Group - Kenwood TH-D72A Instruction Manual

Naming a Memory Group

You can name Memory group using up to 8 characters.
1 Press [MHz], then press [
Tuning control to select a channel in your desired
group.
2 Enter Menu mode and access Menu 144.
3 Enter your desired name for the group.
Group name display (in MR mode)
1 Press [LAMP].
• The group name is displayed.
2 While pressing [LAMP] rotate the Tuning Control to
change the group.
• Rotate the Tuning control clockwise and release
[LAMP] to select the smallest memory channel of the
new group.
• Rotate the Tuning control counter-clockwise and
release [LAMP] to select the largest memory channel
of the new group.

Memory Group Link

Memory Group Link provides you with the ability to
link 2 or more Memory channel groups together to act
as a single group when scanning. You can link up
to 10 separate groups together, or even add multiple
instances of the same group to the group link, to
ensure that one group is scanned more often than the
others.
1 Enter Menu mode and access Menu 145.
2 Press [ OK].
• The cursor will begin blinking.
3 Press [ ]/[ ] or rotate the Tuning control to select
a group to link.
4 Press [ OK] to set the group and move the cursor
to the right.
• Press [ESC ] to move the cursor back or [
move the cursor to the right.
5 Repeat steps 3 and 4 to link additional groups
together.
]/[ ] or rotate the
OK] to
SCAN – 3
6 When you have entered your desired groups, press
[ OK] to move the cursor to the right, then press
the Tuning control to complete the entry and exit
Menu mode.
• You can delete the selected character by pressing
[A/B].
• If you have entered the maximum of 10 groups, simply
[ OK]
press to complete the entry and exit Menu
mode.

Clearing a Memory Group

1 Press [MR] to enter Memory Recall mode.
2 Turn the transceiver power Off.
3 Press [MHz] + Power ON to enter Group Clear
mode.
4 Press [ ]/[ ] or rotate the Tuning control to select
your desired Group.
5 Press [ OK].
• "Sure?" appears on the display and blinks.
6 Press [ OK] or [MR] to clear the Group.
• Repeat steps 4 to 6 to clear additional Group.
• To exit without clearing the channel, press [ESC ].