Dcs Code Scan; Using Cross Tone; Selecting A Cross Tone Mode - Kenwood TH-D72A Instruction Manual

DCS CODE SCAN

This function scans through all DCS codes to identify the
incoming DCS code on a received signal. You may find it
useful when you cannot recall the DCS code that the other
persons in your group are using.
1 Press [TONE] 3 times to activate the DCS function.
• The " " icon appears on the display when the DCS
function is on.
• Each time you press [TONE], the selection changes as
follows:
Tone ( ) CTCSS (
Tone ( : default)
<Additionally, when APRS is ON and Voice Alert is
configured, Voice Alert ON is added to the above cycle.>
2 Press [F], [TONE] (1s).
"
• Scan starts and Scanning
• To quit the scan, press [ESC
• When a DCS code is identified, the identified code
appears on the display and blinks.
3 Press [ OK] to program the identified code in place of
the currently set DCS code.
• The DCS function will remain on. To cancel DCS, press
[TONE] until DCS no longer appears on the display.
• Press [ESC ] if you do not want to program the
identified code.
) DCS ( ) Cross
Off (no display).
"
blinks on the display.
].
CTCSS/ DCS/ CROSS TONE – 3
CROSS TONE

USING CROSS TONE

You can set separate signaling types by TX and RX for
when you access a repeater that uses different Encode/
decode signaling.
To turn the Cross Tone function On:
Press [TONE] 4 times to activate the
• The " " (default) icon appears on the display when the
Cross Tone function is On.
• Each time you press [TONE], the selection changes as
follows:
Tone ( ) CTCSS (
: default) Off (no display).
<Additionally, when APRS is ON and Voice Alert is
configured, Voice Alert ON is added to the above cycle.>

Selecting a Cross Tone mode

To select the cross tone/code frequency required to
access your desired repeater:
1 Turn the
Cross Tone
2 Press [F], [TONE].
• The Cross Tone setting appears on the display.
3 Press [ ]/[ ] or rotate the Tuning control to select
your desired Cross Tone setting.
Setting
DCS/Off
TONE/DCS
DCS/CTCSS
TONE/CTCSS
• To exit the Cross Tone setting selection, press
[ESC ].
4 Press [ OK] to set the selected setting.
function.
Cross Tone
) DCS ( ) Cross Tone (
function On.
Encode Decode
DCS off
Tone DCS
DCS CTCSS
Tone CTCSS
Icon