General Features; Answering A Phone Call; Switching To The Private Mode; Clearing The Disconnection Message - Kenwood KCA-BT100 Instruction Manual

General Features

Answering a Phone Call

When "CALL" or "Call" is displayed, "(Calling party
name)" or "(Phone number)" is also displayed.
Press the [AUDIO] button or one of [1] – [6]
buttons.
Rejecting an Incoming Call
Press the [ATT] button for at least 1 second.
• You can set up the unit so that the incoming call is
received after lapse of a predetermined time. For more
details, see <Setting the Time Interval for Automatic
Answer> (page 11).
• Inserting a disc such as a CD will disconnect your call.
• Setting the cell-phone in the private mode can disable
the hands-free function.
• When a call without caller ID arrives, "No Name No
Number", "No Number", or "NO-NMBER" is displayed.
• The name of the calling party is displayed if it has already
been registered in the Phone Book.

Switching to the Private Mode

You can switch between the private mode (talking
directly on the cell-phone) and the hands-free
mode.
Press the Control knob ([38]).
Talk modes are switched as follows:
Display
"Private"/ "PRIVATE"/ "PV TALK"
"Handsfree"/ – / "HF TALK"
• Depending on the type of your cell-phone, switching
to the private talk mode may select the source that was
used before commencing the hands-free connection.
If this happens, the source cannot be switched back to
the hands-free talk mode by operating this unit. Operate
your cell-phone to return to the hands-free talk mode.

Clearing the Disconnection Message

You can clear the message displayed after
disconnection of the cell-phone.
Press the [ATT] button for at least 1 second.
"Disconnect" or "DISCONCT" disappears.
• It may take some time before the disconnected cell-
phone is reconnected.
6
|
English
(For Audio receiver)
Talk mode
Private talk
Hands-free talk
Adjusting the Voice Volume during a
Call
You can adjust the voice volume during a call.
Turn the [VOL] knob.
• The volume adjusted during the current call will be
effective for the next and subsequent calls.
• Increasing the volume excessively is more likely to
produce echo. If echo is produced, turn down the
volume as low as possible. Echo increases in proportion
to the volume.

Disconnecting a Call

Press the [SRC] button.
• You can also press the [ATT] button for at least 1 second
to end a call.

Switching between Display Modes

You can switch between the Phone Book and the
Call List.
Press the [DISP]/ [AUTO]/ [TI] button.
If the [DISP] button is not provided, press the
[AUTO] or [TI] button.
For the Audio receiver with Multi-function Key System:
Press the [AUTO]/ [TI] button.
Pressing this button toggles between the name list
and the phone number list.
Scrolling the Display
You can scroll through the list of phone numbers
or names. For the operation method, refer to <Text/
Title Scroll> in the Instruction Manual that comes
with the control unit.
• With the control unit on which only the name of the
calling party is displayed when receiving a call or quick
dialing, you can switch to the phone number display
mode by performing the above operation.
• Depending on the type of your control unit, the
following restrictions are placed.
- Up to 19 characters can be displayed.
- The # letter cannot be displayed, or "|" (all segments
are lit) is displayed for #.
- You cannot switch between display modes.