Mower Operation - California Trimmer RL205H Operator's Manual

REEL MOWER OPERATOR'S MANUAL (RL205H/207H)
Operating Controls
4. Throttle Lever
The throttle lever controls the engine speed – as well as
the blade and drive roller speed.
Pivot the lever right to increase, to the left to decrease
On some units, the throttle also controls the engine stop
switch as indicated previously.
5. Cutting Height Adjustment
The cutting height is determined by the position of the
adjustment handle and the front caster axle.
The front caster wheel axle comes standard in the
middle position. It can be removed and placed in the
bottom position to achieve additional settings and lower
cutting heights. NOTE: the top position would be used
only for aftermarket caster wheels or front rollers
that prevent access to the lower cutting heights in
the middle position.
Evergreen Turf Equipment, LLC • 1028 4
The height is changed by moving the adjustment handle
into the positions of the bracket.
**NOTE: Position #8 is
not accessible in the
unit's present
configuration. Actual
cutting height is
affected by many
factors including ground hardness, levelness and
grass conditions.
1. Clothing and Safety Accessories
Always wear safety glasses and appropriate clothing
when operating mower.
2. Starting
The clutch must be disengaged before starting the
engine.
Start the engine carefully and always from behind the
mower. Keep hands and feet well away from blade. If
mower should start to vibrate abnormally, stop the
engine and check for the cause. Vibration is generally a
sign of trouble.
.
3. Engaging Clutch
Squeeze the clutch lever to start the reel and roller
rotation. Note: The reel blade has been adjusted at
the factory and there is slight contact with bed-knife.
Moisture in the grass provides lubrication for the
reel blade. Always disengage the clutch (release the
lever) to stop the reel blade if not cutting grass for
an extended period of time.
4. Mowing
Move the drive roller lift lever forward to lower the roller
and make contact with the ground. Use the clutch lever
to slow the rotation while lowering the roller provides a
smooth take off and helps eliminate any roller marks on
grass.
Avoid loss of control or tipping on slopes and sharp
corners by reducing speed. Stop the blade when
crossing gravel drive, walkways or roads.
th
St. SW, Bldg. A • Auburn, Washington 98001 • caltrimmer.com
Cutting Heights**
Handle
Position
Bottom
#1 1-7/8"
#2 1-3/4"
#3 1-5/8"
#4 1-1/2"
#5 1-1/4"
#6 1"
#7 7/8"

Mower Operation

Caster Axle
Position
Middle
1-3/8"
1-1/4"
1-1/8"
1"
3/4"
5/8"
3/8"