Table of Contents
Advertisement
In this screen you can check the navigation connections. The Reverse (REV) and
Speed-pulse (SPD) connections are necessary for accurate calibration and
functionality.
Menu
1
Select
REV. : With the reverse signal wire connected and
with reverse gear selected, the REV indicator
will change to 'ON'. The current position
cursor will move backwards on the map
screen (whilst the vehicle is reversing).
PKB. : When the handbrake is applied, the destination input is activated.
ILL. : The illumination connection enables automatic switching of the map screen
between day and night mode.
SPD. : The speed-pulse is received from the vehicle's electronics and is necessary to
tell the navigation system how fast the car is moving. This speed is an
approximation and may differ from that shown on the vehicle's speedometer.
GPS : The number of received GPS satellites is shown and the current position,
expressed in Latitude and Longitude.
This function allows you to correct any error in the position or direction of your
vehicle display.
Position
Position
Menu
1
Select
2
Select
3
Move the
OK
4
Use
direction in which you are driving, and select
OK
30
Vehicle Signal
(Navigation Set Up)
(Vehicle Signal).
(Navigation Set Up)
(Calibration).
Position
.
to the correct position and select
.
or
to make
point in the
.
Calibration
Advertisement
Table of Contents
