Kenwood KNA-DV3100 Installation Manual
Dvd navigation system
Hide thumbs
Also See for KNA-DV3100:
- Instruction manual (60 pages) ,
- Service manual (61 pages) ,
- Service manual (34 pages)
Related Manuals for Kenwood KNA-DV3100
Summary of Contents for Kenwood KNA-DV3100
-
Page 1: Installation Manual
KNA-DV3100 DVD NAVIGATION SYSTEM INSTALLATION MANUAL © PRINTED IN JAPAN B54-4407-00/00 (K) (DT) -
Page 2: Safety Precautions
(such as coins or metal tools) inside the unit. • If the unit starts to emit smoke or strange smells, turn off the power immediately and consult your Kenwood dealer. 2CAUTION To prevent damage to the machine, take the following precautions: •... -
Page 3: Installation Procedure
Kenwood dealer. The Mark Position of Your Car Immediately After Installation • Immediately after installation, the information of the GPS satellite is taken in and it may take several minutes to measure the position of the current location. • Immediately after installation, the initial value setting of the gyro sensor is required. After measuring the position of the current location, drive of about 6.2 mile (10 km) and further at a... -
Page 4: Installation
Installation Accessories A...2 B(M5X8mm)...4 E...1 I...1 Installation for Navigation System 2CAUTION • Select for installation a location where the unit can be placed completely horizontal. • Be sure to firmly stabilise this product. Do not install it in a location which is not stable. 2WARNING Check that there are no wiring cables or other parts beneath the floor mat before cutting the floor mat. - Page 5 Installation of the GPS Antenna 2CAUTION • GPS antenna D can be installed either inside or outside of the car, but either way it should be installed as horizontally as possible to allow easy reception of the GPS satellite signals.
- Page 6 Connection To the monitor unit ("NAV I/F" terminal) 2CAUTION When disconnecting the interface cable, pinch and pull the ring of the connector. If you pull other parts of the connector, the locking mechanism of the connector is not released, which may damage the connector. 2WARNING For the sake of safety, be sure to connect the parking sensor wire.
- Page 7 Attaching Remote Control Sensor When using a TV monitor other than ones manufactured by KENWOOD, attach the Remote Control Sensor following the procedure below: Remove the backing paper from the double-sided tape and attach the tape to the back of the Remote Control Sensor.