Advertisement
The siren will continue for 30s
before stopping. Any further
triggering of the alarm by
movement in front of the PIR will
immediately re-activate the siren
for a further 30s period.
To stop the Alarm enter the 4
digit User Access Code.
Disarming the Alarm / Exiting
Chime Mode:
Enter the 4 digit User Access
Code. The alarm will beep as
each digit is entered. A single
beep will indicate that the User
Access Code is correct and the
system has disarmed.
Note: A double beep will be
produced if the User Access Code
has been entered incorrectly.
Low Battery Warning:
A low battery level is indicated by
the LED indicator continuously
flashing every 1.5s, (except during
the entry/exit delay period).
TESTING
It is recommended that the
system is tested immediately
after installation and at regular
intervals not exceeding 1 month.
To test the system, ARM the
alarm. After allowing the 45s
exit-delay to expire trigger
the alarm by walking in front
of the PIR. After the 30s entry
delay has expired the siren will
activate.
DISARM the alarm to stop the
siren.
Note: A cloth can be used to
cover the siren and reduce the
sound output of the alarm during
testing.
TROUBLE SHOOTING
Alarm Unit Not Operating
Batteries low, flat, missing or
incorrectly fitted.
Incorrect User Access Code
entered.
Advertisement
