Advertisement
Quick Links
MA5 - Motion Alarm
Installation and Operating Instructions
These instructions should be retained in a safe place for future reference.
Kit Contents:
1 x PIR Alarm Unit and Wall
Mounting Bracket
1 x Fixings Pack
1 x Instruction Leaflet
1 x Window Sticker
Tools and Equipment Required:
No.0 Philips Screwdriver
No.1 Philips Screwdriver
Drill and 6.5mm Masonry Drill Bit
3 x 1.5V AAA (LR03) Alkaline
Batteries for PIR Alarm Unit
SAFETY
Always follow the manufacturers
advice when using power tools;
steps, ladders etc. and wear
suitable protective equipment
(e.g. safety goggles) when
drilling holes etc.
Before drilling holes in walls,
check for hidden cables and
pipes, the use of a cable/pipe
locater may be advisable if in
doubt.
The use of ear protection is
advisable when working in close
proximity to the Siren due to the
high sound level produced by
this device.
Advertisement
Summary of Contents for Firedland MA5
- Page 1 MA5 - Motion Alarm Installation and Operating Instructions These instructions should be retained in a safe place for future reference. Kit Contents: SAFETY 1 x PIR Alarm Unit and Wall Always follow the manufacturers Mounting Bracket advice when using power tools;...
- Page 2 PIR Movement INTRODUCTION Sensor The Alarm can be either wall mounted using the bracket supplied or used freestanding for portable use. The Alarm is operated using a 4 Siren digit User Access Code with the keypad on the front of the alarm. Indicator Keypad Passive Infra-Red (PIR) detectors...
-
Page 3: Installation
1) Where possible, mount the INSTALLATION detector in the corner of the 1) Hold the mounting bracket in room where the logical path of position on the wall and mark an intruder would be across the position of the two fixing the device. -
Page 4: System Operation
Code. The alarm will beep SYSTEM OPERATION when each digit is entered. Changing the 4 digit User When the 4th digit is entered Access Code: (default setting: the alarm will beep twice to 1234) confirm the new code has been accepted. 1) First ensure the system is Disarmed and then remove If the LED stops flashing... - Page 5 the confirmation beep start Operating in the Alarm Mode: the process again. To activate ALARM mode the mode selector switch in the 5) Refit the battery cover and battery compartment must first replace the fixing screw. be set to the ALARM position. 6) Refit the Alarm to the Enter the 4 digit User Access mounting bracket.
-
Page 6: Troubleshooting
The siren will continue for 30s TESTING before stopping. Any further It is recommended that the triggering of the alarm by system is tested immediately movement in front of the PIR will after installation and at regular immediately re-activate the siren intervals not exceeding 1 month. -
Page 7: Maintenance
PIR Causing False Alarms Replacement 3 x AAA (LR03) Batteries: Alkaline Batteries PIR Badly positioned, (e.g. in direct sunlight, draughts, Typical Life: up to 1 year above a radiator etc.). Important: Take care to insert the batteries with the correct MAINTENANCE polarity as shown inside the The product may be cleaned with... - Page 8 GUARANTEE Novar ED&S undertakes to replace or repair at its discretion goods (excluding non rechargeable batteries) should they become defective within 2 years solely as a result of faulty materials and workmanship. Understandably if the product has not been installed, operated or maintained in accordance with the instructions, has not been used appropriately or if any attempt has been made to rectify, dismantle or alter the product in any way the guarantee will be invalidated.