Advertisement
Code. The alarm will beep
when each digit is entered.
When the 4th digit is entered
the alarm will beep twice to
confirm the new code has
been accepted.
If the LED stops flashing
before the code is entered or
the alarm does not produce
the confirmation beep start
the process again.
6) Select the required operating
mode for the alarm, (i.e.
ALARM or CHIME mode)
using the slide switch in the
battery compartment.
7) Replace the battery cover and
fixing screw.
8) Clip the PIR Alarm Unit onto
the mounting bracket and
adjust the unit until it is at the
required angle and direction.
SYSTEM OPERATION
Changing the 4 digit User
Access Code: (default setting:
1234)
1) First ensure the system is
Disarmed and then remove
the Alarm from the wall
bracket.
2) Undo the Battery Cover Fixing
screw and remove the battery
cover.
3) Press the LEARN button in
the battery compartment.
4) The indicator LED on the front
of the Alarm will flash for 15s.
During this period you must
enter your new 4 digit User
Access Code. The alarm will
beep when each digit is
entered. When the 4th digit is
entered the alarm will beep
twice to confirm the new code
has been accepted.
If the LED stops flashing
before the code is entered or
the alarm does not produce
Advertisement
