Advertisement
the confirmation beep start
the process again.
5) Refit the battery cover and
replace the fixing screw.
6) Refit the Alarm to the
mounting bracket.
Operating in the Chime Mode:
To activate CHIME mode the
mode selector switch in the
battery compartment must first
be set to the CHIME position.
Enter the 4 digit User Access
Code. The alarm will beep as
each digit is entered. A door-
chime sound will indicate that
the User Access Code is correct
and the system has armed.
Note: A double beep will be
produced if the User Access
Code
has
incorrectly.
The alarm will produce a door-
chime sound each time the PIR
senses movement.
been
entered
Operating in the Alarm Mode:
To activate ALARM mode the
mode selector switch in the
battery compartment must first
be set to the ALARM position.
Enter the 4 digit User Access
Code. The alarm will beep as
each digit is entered. The LED
indicator will start flashing, the
flashing will continue until the
45s exit-delay expires, at which
point the Alarm will be armed.
The exit-delay allows time for
you to leave the protected area
without triggering the alarm.
Note: A double beep will be
produced if the User Access Code
has been entered incorrectly.
If movement is detected while
the system is armed then the
alarm will beep and the LED
indicator will start flashing. This
continues until the 30s entry-
delay expires at which point the
siren will activate. The entry-
delay allows time for you to
DISARM the alarm before the
siren activates.
Advertisement
