Locations And Directions - Sanyo PLC-XU355A Service Manual

Optical Parts Disassembly

8. Locations and Directions

When mounting or assembling the optical parts in the opti-
cal unit, the parts must be mounted in the specified loca-
tion and direction as shown in figure below.
1
2
3
4
Point marker is
printed on this side
up.
5
P o i n t m a r k e r i s
printed on this side
up.
6
7
9
8
P o i n t m a r k e r i s
printed on this side
No. Parts Name
1 Integrator lens (IN)
2 Integrator lens (OUT)
3 Prism beam splitter (PBS)
4 Condenser lens (OUT)
5 Dichroic mirror (B)
6 Dichroic mirror (G)
7 Condenser lens (G)
8 Mirror (R)
9 Relay lens (IN)
10 Condenser lens (R)
11 Condenser lens (B)
12 Mirror (B)
The rugged surface is
facing this side.
Rugged surface is
facing this side.
Film attached side
is facing this side.
P o i n t m a r k e r i s
printed on this side
P o i n t m a r k e r i s
printed on this side
-23-
12
11
10
8
Fig.8