Skoda 2014 Fabia Owner's Manual page 33

The display is updated regularly while you are driving.
Range
The estimated range is displayed in kilometres. It indicates the distance you
can still drive with your vehicle based on the level of fuel in the tank and the
same style of driving.
The display is shown in steps of 10 km. The value is displayed in steps of 5 km
after the warning light has come on.

The fuel consumption over the preceding 50 km is used to calculate the infor-
mation. The range will increase if you drive in a more economical manner.
If the memory is set to zero (after the battery has been disconnected), a fuel
consumption of 10 l/100 km is used initially, then the value is adapted accord-
ing to the style of driving.
Distance travelled
The distance travelled since the memory was last erased is displayed. Reset
the memory to zero if you want to measure the distance travelled from a par-
ticular moment » page 30, Operation.
The maximum distance indicated in both memories is 1999 km or 9999 km on
vehicles with a MAXI DOT display. The indicator is reset to zero when this val-
ue is exceeded.
Average speed
The average speed since the memory was last erased is displayed in km/hour .
Set the memory to zero at the start of measurement to determine the average
speed over a certain period » page
No value will appear in the display until you have driven approximately 300 m
after this information has been deleted.
The display is updated regularly while you are driving.
Current speed
The current speed, identical to the display on the speedometer
page 26, is displayed.
Oil temperature
1)
The current engine oil temperature is displayed. If the oil temperature is lower
than 50 °C or if a fault in the system for checking the oil temperature is
present, only - -.- is displayed instead of the oil temperature.
1)
Applies for vehicles equipped with the MAXI DOT display.
2)
An initial value of 30 km/h is displayed automatically if no value has been specified.
30, Operation.
» Fig. 19
3
Warning against speeding
The warning that the speed limit is being exceeded can be enabled/disabled in
the display » page 31.
Warning against speeding

Read and observe
Adjust the speed limit while the vehicle is stationary
›
Press button » Fig. 22
A
display) or  (segment display) menu item.
›
Press button to activate the ability to set the speed limit
B
›
Use the button to set the required speed limit, e.g. 50 km/h.
A
›
Confirm the speed limit that was set with button
onds until the setting is saved automatically (the value stops flashing).
This allows you to set the speed in 5 km/h intervals.
Adjusting the speed limit while the vehicle is moving
›
Press button » Fig. 22
A
display) or  (segment display) menu item.
›
Drive at the desired speed, e.g. 50 km/h.
›
Press button to accept the current speed as the speed limit (the value
B
flashes).
If you wish to adjust the set speed limit, you can do so in 5 km/h intervals (e.g.
the accepted speed of 47 km/h increases to 50 km/h or decreases to 45 km/h).
›
Confirm the speed limit that was set by pressing button
prox. 5 seconds until the setting is saved automatically (the value stops
flashing).
Change or delete speed limit
›
Press button » Fig. 22
A
display) or  (segment display) menu item.
›
on
Pressing button disables the speed limit.
B
›
Pressing the button
B
If the set speed limit is exceeded, an audible signal will sound as a warning.
The Warning at (MAXI DOT display) or  (segment display) menu item appears
in the display with the limit set.
on page 29 first.
on page 30 to select the Warning at (MAXI DOT
, or wait approx. 5 sec-
B
on page 30 to select the Warning at (MAXI DOT
on page 30 to select the Warning at (MAXI DOT
activates the ability to change the speed limit.
Instruments and Indicator Lights
(value flashes).
2)
again, or wait ap-
B

31