To Connect A Pcm Digital Output Laser Disc Player - Kenwood KRF-X9992D Connection And Setup Manual

Chapter One : Connecting Your Devices
Connecting Your Laser Disc Player (without AC-3 RF Output), continued
Do not plug in the receiver to AC power until you
have connected all your devices.
These instructions describe how to connect a laser
disc player with a PCM Digital Output. If your
player has a Dolby Digital (AC-3) RF Out, see
"Connecting Your Laser Disc Player (with AC-3 RF
Output)" on page 24. This configuration does not
allow Dolby Digital laser discs to be played. Please
refer to your laser disc player's instructions for more
detail about its connection jacks and capabilities.
The instructions in this section show one of several
possible variations on connecting your laser disc
player. For further assistance on optional configura-
tions, contact the store where you purchased your
receiver.
To Connect a PCM Digital Output Laser
Disc Player:
1. Review the information under "Before You
Begin" on page 1. It contains important notes
about the types of video connections you can
make.
2. Look at the digital connection on your laser disc
player. Use the table below to choose a jack set:
If your digital Choose this jack
cable is... set...
optical VIDEO4
coaxial VIDEO2 or 3
Note that the jack sets are linked, even though
they are not adjacent. You must connect all of
the cables from your laser disc player to a linked
jack set. If you connect the analog cables to
VIDEO2 and the digital optical cable to
VIDEO4, your laser disc player will not work
correctly.
3. Connect the audio cables from the laser disc
player's Audio OUT jacks to the receiver's AUDIO
jacks as shown to the left.
Audio-Video Receiver KRF-X9992D
4. Connect the video cable from the laser disc
player's Video OUT jack to the receiver's VIDEO
PLAY IN jack as shown to the left.
5. Connect the digital cable (either coaxial or
optical) from the laser disc player's digital jack to
the appropriate digital jack on the receiver as
shown to the left. Your laser disc player supports
only one of the digital connection methods—do
not connect both.
If you use the optical digital cable, be sure to
remove the protective cover from the optical jack
before connecting.
6. Go to "Noting Your Devices" on page 3 and note
which jacks you used to connect your laser disc
player. In addition, note the brand name and
model number of the laser disc player.
27