To Connect A Dvd Player - Kenwood KRF-X9992D Connection And Setup Manual

Digital audio/video reciever
Hide thumbs Also See for KRF-X9992D:
Table of Contents

Advertisement

Chapter One : Connecting Your Devices
Do not plug in the receiver to AC power until you
have connected all your devices.
This section focuses on the connections from your
DVD player to the KRF-X9992D. Please refer to your
DVD player's instructions for more detail about its
connection jacks and capabilities.
The instructions in this section show one of several
possible variations on connecting your DVD player.
For further assistance on optional configurations,
contact the store where you purchased your receiver.
DTS disclaimer clause
DTS Digital Surround™ is a discrete 5.1 channel digital audio format available on CD, LD, and DVD software which consequently cannot be decoded and played back
inside most CD, LD, or DVD players. For this reason, when DTS-encoded software is played back through the analog outputs of the CD, LD, or DVD player, excessive
noise will be exhibited. To avoid possible damage to the audio system, proper precautions should be taken by the consumer if the analog outputs are connected
directly to an amplification sysem. To enjoy DTS Digital Surroud™ playback, an external 5.1 channel DTS Digital Surround™ decoder system must be connected to the
digital output (S/PDIF, AES/EBU, or TosLink) of the CD, LD or DVD player.
Connecting Your DVD Player, continued

To Connect a DVD Player:

1. Review the information under "Before You
Begin" on page 1. It contains important notes
about the types of video connections you can
make.
2. Look at the digital cable that came with your
DVD player. Use the table below to choose a jack
set:
If your digital
Choose this jack
cable is...
set...
optical
VIDEO4
coaxial
VIDEO2 or 3
Note that the jack sets are linked, even though
they are not adjacent. You must connect all of
the cables from your DVD player to a linked jack
set. For example, if you connect the analog cables
to VIDEO2 and the digital optical cable to
VIDEO4, your DVD player will not work cor-
rectly.
Audio-Video Receiver KRF-X9992D
3. Connect the audio and video cables from the
DVD's Audio and Video jacks to the receiver's
PLAY IN jacks as shown to the left.
4. Connect the digital cable (either coaxial or
optical) from the DVD's digital jack to the
appropriate digital jack on the receiver as shown
to the left.
The illustration shows two digital connections,
one for coaxial connection and one for optical
connection. Your DVD player supports one or
the other of these connection methods—do not
connect both.
If you use the optical digital cable, be sure to
remove the protective cover from the optical jack
before connecting.
5. Go to "Noting Your Devices" on page 3 and note
which jacks you used to connect your DVD
player. In addition, note the brand name and
model number of the DVD player.
17

Advertisement

Table of Contents
loading

Table of Contents