Wolf CGG-1K-24 Installation And Operating Instructions Manual page 27

2. Adjusting the control unit:
ON / OFF switch
ON / OFF
- At the system ON / OFF switch, switch the boiler first OFF
and then ON again. There must not be any fault present at the
boiler.
- Press the reset button (within the following 30 seconds) and
it hold down during the next steps.
- After 5 seconds, the illuminated signal ring indicates the
currently selected gas type (see table adjusting the gas type).
- Turn the heating water temperature selector towards the
required gas type and check the setting by means of the colour
of the illuminated signal ring (see table adjusting the gas type).
- The adjustment will only be activated when the reset button is
released.
- A successful conversion of the gas type is indicated by a triple
flashing (yellow/red) of the signal ring.
Gas type
Signal ring
Heating water temperature adjustment
Table: Adjusting the gas type
Check the nozzle pressure after converting
NB
the gas type, otherwise material losses and
incorrect functions can occur.
3062087_0207
Conversion to other gas types
Reset
button
temperature
Illuminated
signal ring
Natural gas
quickly flashing yellow
l.h. end stop
DHW
selector
Heating water
temperature selector
Thermometer
Pressure
gauge
LPG
quickly flashing red
r.h. end stop
2 7