Q.check Out - Sunrise Medical QUICKIE S-636 Owner's Manual

S - 6 3 6
Never use a high-powered washer for cleaning the shock. Always use mild soap
and a small brush.
2. Damping Adjustment
The Rock Shox suspension system used on the S-636 SC/S-636 MPC has the ability to adjust
the rebound (damping) of the suspension. Rebound or damping is the rate at which the
spring returns to its original position after experiencing a deflection.
a) Adjustment of the rebound (damping) is done by turning the red knob (C) on the sus-
pension. Turning the red knob clockwise slows the rate of return or decreases the
rebound. Turning the red knob counterclockwise quickens the rate of return or
increases the rebound.
b) Too much rebound will feel like the system stiffens over a bumpy surface. Adjust the
red knob a half turn counterclockwise and test for performance.
c) Too little rebound will feel like the system is trying to buck the rider out of the seat.
Turn the red knob a half turn clockwise and test for performance.
Q.CHECK-OUT
Once the wheelchair is assembled and adjusted, it should roll smoothly and easily.
All accessories should also perform smoothly.
After the wheelchair has been set up be sure the chair performs to your specified
operational settings (see section X. Operating Guide). If the chair does not perform to specifi-
cations, turn the wheelchair OFF immediately and reprogram operational specifications using
the QTRONIX Programming Pad.
Repeat this procedure until the wheelchair performs to specifications before
attempting active use of the wheelchair.
If you have any problems, follow these procedures:
1. Review the set-up and check-out section and operating guide to make sure
chair was properly prepared.
2. If your problem persists, contact your authorized supplier. If you still have a
problem after contacting your authorized supplier, contact Sunrise customer
service. See the introduction page for details on how to contact your author-
ized supplier or Sunrise customer service.
WARNING
17
I X .
108833 Rev. A