Table of Contents
Advertisement
Chapter 1: Connection of Equipment
This manual describes the standard, most typical
connections of the player. When an associated system
component is connected, also refer to their instruction
manuals.
For details on the connection of the following
components, see the indicated reference pages.
Connection with a TV or Stereo System
Connection with an AV Amplifier
Before Start
Do not install the player in a place where the remote
control sensor is subjected to direct sunlight or the
light of a fluorescent lamp base on high-frequency
lighting (inverter system, etc.). Otherwise, the control
range of the joystick remote will be reduced.
0
Do not insert the power cord plugs of the player and
the connected components until all of the components
@
have been connected.
Be sure to insert all connection cables securely. If a
cable is plugged incompletely, lack of video, lack of
audio or noise may result.
Before connecting or disconnecting a connection cord,
be sure to unplug the power plug from the wall power
outlet. If a connection cable is connected or
disconnected while the power plug is left connected,
malfunction or equipment damage may result.
When a DVD AUDIO disc is played, the player can output
audio signals at very high frequencies. As this may
sometimes lead to speaker damage due to a high-volume
sound, do not set "Audio Filter" to "Filter 110 kHz"
when the speakers in use are not suitable for high-
frequency reproduction.
Also, be sure to check the actual sound level when
increasing or decreasing the volume control setting.
Chapter 1: Connection of Equipment
Malfunction of Microcomputer
In case the microcomputer malfunctions, making
operations impossible or showing wrong messages on
the display even if you connected everything properly.
When the microcomputer malfunctions, perform the
following procedure to reset the microcomputer and
return it to the normal condition.
1.
While holding
7
POWER
press
.
- ON – OFF
2.
The display on the main unit shows blinking
"INIT"(initializing), then shows "INIT OK!" (Ini-
tialization OK) to indicate that the microcomputer
is reset.
POWER
3.
Press
on the main unit to turn it off, then
- ON – OFF
press it again to turn it on.
¶ The resetting clears the setups stored in the
microcomputer and returns it to the factory-set
initial condition. After resetting, you should
perform the various setups of the player again
from the beginning.
‹
on the player main unit,
9
Advertisement
Table of Contents
