Temperature And Moisture; Ice And Water - Viking Freestanding French DoorBottom-Mount Refrigerator/Freezerwith Dispenser Use & Care Manual

Freestanding french door bottom-mount refrigerator/freezer with dispenser
Table of Contents

Advertisement

Troubleshooting

Temperature and Moisture

Problem
Cause
Temperature is
New installation?
too warm
Door(s) opened often or left
open?
Large load of food added?
Controls set correctly for the
surrounding conditions?
There is interior
High humidity?
moisture buildup
ote: Some
Door(s) left open?
moisture buildup
is normal.
28
(cont.)
Solution
Allow 24 hours following
installation for the
refrigerator to cool
completely.
Allows warm air to enter
refrigerator. Minimize door
openings and keep doors
fully closed.
Allow several hours for
refrigerator to return to
normal temperature.
Adjust the controls a setting
colder. Check temperature in
24 hours. See "Using the
Controls".
Minimize door openings and
keep door(s) fully closed.
Keep door(s) fully closed.
Troubleshooting

Ice and Water

Problem
Cause
The ice maker is
Refrigerator connected to a
not producing
water supply and the supply
ice or not
shutoff valve turned on?
enough ice
Kink in the water source
line?
Ice maker turned on?
New installation?
Freezer door closed
completely?
Large amount of ice recently
removed?
Ice cube jammed in the ice
maker ejector arm?
Water filter installed on the
refrigerator?
Reverse osmosis water
filtration system connected
to your cold water supply?
The ice cubes are
Water shutoff valve not fully
hollow or small
open?
ote: This is an
Kink in the water source line?
indication of low
water pressure.
Water filter installed on the
refrigerator?
Reverse osmosis water
filtration system connected
to your cold water supply?
29
(cont.)
Solution
Connect refrigerator to
water supply and turn water
shutoff valve fully open.
A kink in the line can reduce
water flow. Straighten the
water source line.
Make sure wire shutoff arm
or switch (depending on
model) is in the ON position.
Wait 24 hours after ice maker
installation for ice production
to begin. Wait 72 hours for
full ice production.
Firmly close the freezer
compartment door. If the
freezer compartment door
will not close all the way, see
"The doors will not close
completely".
Allow 24 hours for ice maker
to produce more ice.
Remove ice from the ejector
arm with a plastic utensil.
Remove filter and operate
ice maker. If ice volume
improves, then the filter may
be clogged or incorrectly
installed. Replace filter or
reinstall it correctly.
This can decrease water
pressure. See "Water Supply
Requirements".
Turn the water shutoff valve
fully open.
A kink in the line can reduce
water flow. Straighten the
water source line.
Remove filter and operate
ice maker. If ice quality
improves, then the filter may
be clogged or incorrectly
installed. Replace filter or
reinstall it correctly.
This can decrease water
pressure. See "Water Supply
Requirements".

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Freestanding French DoorBottom-Mount Refrigerator/Freezerwith Dispenser and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents