Subscribe to Our Youtube Channel
Related Manuals for Viking F20712D
Summary of Contents for Viking F20712D
-
Page 1: Installation Guide
Installation Guide Freestanding French Door Bottom-Mount Refrigerator/Freezer with Dispenser... -
Page 2: Table Of Contents
Table of Contents Warnings & Important Information_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 3 Dimensions (36”... -
Page 3: Warnings & Important Information
IMPORTANT – Please Read and Follow It is the customer’s responsibility to: • Contact a qualified electrical installer. • DO NOT service or replace any part of • Read all instructions before using the refrigerator unless specifically refrigerator. recommended in Use & Care or Installation •... - Page 4 Refrigerator Safety...
- Page 5 • Viking Range, LLC will NOT warranty any problems resulting from GFI outlets which are not installed properly or do not meet the requirements below.
-
Page 6: Dimensions (36" Bottom-Mount & French Door Bottom-Mount)
Dimensions (Professional) 36” Professional French Door - 7 / s i d ( 9 1 8 ” e l s s s o - 3 / ( 1 1 2 . 2 ” - 7 / ( 1 8 8 ” 2 . -
Page 7: Specifications (36" Bottom-Mount & French Door Bottom-Mount)
Specifications (Professional) Professional French Door Bottom-Mount Description VCFF136D Overall width 35-5/8” (90.5 cm) Addition of side panels: 35-7/8” (91.1 cm) Overall height To top of door: 69-7/8” (177.5 cm) min. to 70-5/8” (179.4 cm) max. To top of hinge cap: 69-5/8” (176.8 cm) min. to 70-3/8” (178.8 cm) max. To top of cabinet: 68-3/8”... -
Page 8: Proper Disposal
Proper Disposal (of old refrigerator) IMPORTANT: Child entrapment and suffocation are not problems of the past. Junked or abandoned refrigerators are still dangerous - even if they will sit for “just a few days.” If you are getting rid of your old refrigerator, please follow these instructions to help avoid accidents. -
Page 9: General Information
General Information Clean Before Using Your refrigerator was packed carefully for shipment. Remove and discard all packaging and After you remove all of the packaging materials, tape. DO NOT remove the model/serial number clean the inside of your refrigerator before using label. -
Page 10: Moving Refrigerator
General Information Electrical Requirements To ensure proper ventilation for your refrigerator, allow for a 1/2" (1.25 cm) space on each side and at the top. Allow 1" (2.5 cm) of space behind the refrigerator. If your refrigerator has an ice maker, allow extra space at the back for the water line connections. -
Page 11: Water Supply Requirements
General Information Water Supply Requirements A cold water supply with water pressure of Reverse Osmosis Water Supply (cont.) between 35 and 120 psi (241 and 827 kPa) is • If your refrigerator has a water filter, it may required to operate the water dispenser and ice further reduce the water pressure when used in maker. -
Page 12: Remove And Replace Handles
Doors & Drawer Removal Remove and Replace Handles Remove Doors and Hinges (cont.) 1. Using a 3/32"or 1/8” hex wrench, loosen the 6. Disconnect the water line by holding the tabbed two set screws located on the side of each section of the water line while turning the black handle. -
Page 13: Replace Doors And Hinge
Door & Drawer Removal (cont.) Replace Doors and Hinges Replace Drawer Front 1. Assemble the parts for the top hinge as shown 1. Slide the drawer glides out of the freezer in Top Hinge graphic. DO NOT tighten the compartment. Insert the screws in the top of screws completely. -
Page 14: Installation
Installation Water Supply Requirements Connect the Water Supply Gather the required tools and parts before IMPORTANT: If you turn the refrigerator on starting installation. Read and follow the before the water line is connected, turn the ice instructions provided with any tools listed here. maker OFF. - Page 15 Installation Connect to Water Line (cont.) 6. Fasten the shutoff valve to the cold water pipe 5. Using an adjustable wrench, hold the nut on with the pipe clamp. Be sure the outlet end is the plastic water line to keep it from moving. solidly in the 1/4"...
-
Page 16: Leveling
Leveling To enhance the appearance and maintain performance, the refrigerator should be level. To protect property and refrigerator from damage, observe the following: • Protect vinyl or other flooring with cardboard, rugs, or other protective material. DO NOT • use power tools when performing leveling procedure. Materials Needed •... -
Page 17: Door Alignment
Door Alignment (French Door Bottom-Mount) To raise left side door, turn leveler foot Remove toe grille. Grasp firmly and pull outward to screw clockwise. unclip. To raise left side door, turn leveler foot Replace toe grill. Align the toe grille mounting clips screw clockwise. -
Page 18: Performance Checklist
Performance Checklist □ Plug-in refrigerator and verify operation. Installer’s information: □ Connect water supply (if applicable). Installer’s name:_____________________________ • Verify icemaker bail arm is down. • Verify dispenser operation Installer’s company:____________ ______________ (if applicable). □ Align/square door(s). Date:_______________________________________ □ Verify drain pan properly installed and no leaks on water connection. -
Page 19: Service & Registration
Only authorized replacement parts may be used in performing service on the appliance. All servicing should be referred to a qualified technician. Contact Viking Range, LLC, 1-888-(845-4641), for the nearest service parts distributor in your area or write to: VIKING RANGE, LLC... - Page 20 Viking Range, LLC 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-(845-4641) or visit the Viking Web site at vikingrange.com in the U.S. or brigade.ca in Canada. (053113) F20712D EN W10345055...
Need help?
Do you have a question about the F20712D and is the answer not in the manual?
Questions and answers