Installation - Fisher & Paykel Smart Drive Use & Care Manual

INSTALLATION
INSTALL.ATION
INSTALLING
To ensure the best performance from your new
1. Uncoil power cord.
Smart Drive please read the following
instructions carefu IIy. - .
2~
Remove the blaCK ribbed drain hose from
the fixture on the left hand side of the rear
UNPACKING
panel by carefully pulling the exposed part ­
1. Having removed the outer packaging, leave
l.
of the hose downwards and outwards.
the machine standing upright in the bottom
-cardboard packer.
3. Connect drain hose to tub or standpipe. The
hose guide, included in the accessory kit, is
2.
Lift.
lid and remove bowl packer from bowl..
to guide the drain hose over the tub'or
sta-ndpipe. It MUST be fitted to the drain
hose. The-drain hose should not extend
3. Remove hoses and accesso.r-ies.
4. Rotate
the
agitator anti-clockwise for 3
more than 20mm from the end oHhe guide
revplutions to unscrew the transit restraint.
(this is to prevent sypho'ning). If nece_ssary
(The wash bowl will then be free to move
the drain
ho~e
can be trimmed to le-ngth.
from side to side.)
4. Place filtered sealingwashers (from
-5. Flatten the bottom cardboard packer,
accessory kit) into straight end of the plastic
remove machine checking the transit
inlet hoses and connect to taps.
restrainthas come away with the cardboard
packer. Keep the transit restraint and bowl
5. Place sealing washers (from accesso:ry kit)
packer in case they are required for ftlture ­
,
into the elbow ends of plastic inlet hoses
transit. ­
FILTERED
and connect to machine inlet valves. ­
SEALING
Inlet valves are marked on the .rear of
WASHER
~
machine.
H hot C = cold
PLEASE ENSURE THE TRANSIT RESTRAINT
Turn on water and .check hose connections
HAS BEEN REMOVED BEFORE OPERATING
TAP END
YOUR MACHINE.
for leaks.
6. Move the machine into its final position.
(We suggest a minimum clearance of 20mm
either side of the machine for ease of
SEALING
WASHE.R
installation.)
Make sure there are no kinks inthe hoses.
7. It is IMPORTANT to level the machine.
Fit the rubber inserts into the feet on the
base of the machine. Adjust the feet to
make sure the machine is level.
MACHINE
1:)
(RefE1r to page 5.)
END
8. Make sure the machine is firm on all
levelling feet.
9. Plug power cord into wall socket.
BOTTOM •
CARDBOARD PACKER
3
2
ROTATE ANTI-CLOCKWI'SE