Advertisement
Important Safeguards
When using electrical equipment, basic safety precautions should always be followed including:
•
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
•
Do not use outdoors.
•
Do not mount near gas or electric heaters or near flammable materials.
•
Do not use this equipment for other than intended use.
•
Always follow, local and national safety codes and requirements when using or mounting equipment.
•
Refer service to qualified personnel.
Introduction
LEKO LITE Luminaires are designed to conform to the latest safety standards and requirements. The following describes
the safety and operational information on the luminaire's label.
Luminaire operational voltage range.
Do not mount luminaire on, or allow contact
with, flammable materials.
Luminaire
model
number
and
manufacture date code.
For any
warranty service, you must provide the
model number and proof of purchase.
Specifies the minimum distance from the luminaire to a
flammable surface. The top figure is to a surface in the
light beam and the bottom figure to a surface near the
luminaire body.
Figure 1: Luminaire Warning Label
Compliance
All LEKO LITE Luminaires are ETL-listed and conform to all applicable CE requirements. You
should adhere to all local and national safety requirements and codes when mounting and using
the LEKO LITE Luminaire.
© 2010, Philips Group. All rights reserved. The material in this manual is for information purposes only and is subject to change
without notice. Strand Lighting assumes no responsibility for any errors or omissions, which may appear in this manual. Informa-
tion contained in this document may not be duplicated in full or in part by any person without prior written approval of Strand
Lighting. Its sole purpose is to provide the user with detailed installation information for the equipment supplied. The use of this
document for all other purposes is specifically prohibited. Additional information for this and all Strand Lighting products can be
found at www.strandlighting.com.
1
Tmax specifies the maximum surface
temperature for the luminaire body.
Ta specifies the maximum ambient
operating temperature for the luminaire.
C
Pan and Tilt Adjustment
CAUTION: When adjusting the luminaire's position, it is important to wear protective gloves. The luminaire produces
extreme heat and all surfaces could cause serious burns if touched.
Pan Adjustment
The pan adjustment of a LEKO LITE luminaire is achieved by loosening the yoke bolt or yoke bolt set screw of the securing
clamp attached to the luminaire's yoke assembly. Loosen the bolt or set screw, set the luminaire to the desired position
and retighten.
Tilt Adjustment
LEKO LITE Luminaires offer variable tilt settings. The unit can be set at a specific angle (in relation to its mounting
position) or at an angle between 0 to 90 degrees. When the yoke is in the position shown in Figure 5, you have full range
access to shutters the gate etc. If you flip the yoke over some access is reduced but the over all volume the luminaire
takes up is reduced. This is particularly useful in tightly hung lighting positions or in theatres with low grids.
To set the tilt angle of the luminaire:
1.
Install luminaire in desired location (see "Accessories / Installation / Mounting" section for additional information).
2.
Loosen, but do not remove, T-Handle Tilt Locks at base of yoke assembly as shown in Figure 5.
3.
Position luminaire to desired position.
4.
Retighten T-Handle Tilt Locks to set position.
T-Handle Tilt Lock
Luminaire Tilt Label Detail
Figure 5: Luminaire Positioning
LEKO LITE Luminaire User's & Installation Guide
Yoke Assembly
T-Handle Tilt Lock
6
Advertisement
