Download Print this page
Philips Leko Lite 11430C User's Installation Manual

Philips Leko Lite 11430C User's Installation Manual

Leko lite luminaire
Hide thumbs Also See for Leko Lite 11430C:

Advertisement

Beam Shutter Operation
CAUTION: When adjusting the luminaire's beam shutter, it is important to wear protective gloves. The luminaire produces
extreme heat and all surfaces could cause serious burns if touched.
Each LEKO LITE Luminaire is equipped with four
independent shutters (as shown in Figure 6) to block
or shape light as desired. After the luminaire is
installed and positioned, move the shutters in or out
as required.
Gobos
Each LEKO LITE Luminaire is capable of holding two
gobo holders, each containing one "B" sized glass or
steel gobo.
To install or change a gobo:
1.
As shown in Figure 7, loosen, but do not
remove, two retaining knobs that secure gobo
access panel. Slide open gobo access panel.
2.
Install gobo into gobo holder in desired
orientation.
3.
Slide gobo holder into luminaire gobo slot.
4.
Close gobo access door. Make sure gobo
holder handle fits inside one of two slots in
gobo access panel.
5.
Hand tighten gobo access panel retaining
knobs.
Maintenance & Cleaning
Lenses, reflector, gobos, lamps, etc. should only be
cleaned with isopropyl alcohol and never with any
ammonia-based product. Also, cleaning should only
be done with power completely removed from the
luminaire and the luminaire cool to the touch.
Note: For extremely dirty lenses, a mild soap/detergent and distilled water solution should be used prior to cleaning with
Isopropyl Alcohol. Always use a soft, lint free cloth after blowing away loose particulates with clean, oil-free air.
Strand Lighting Offices:
Strand Lighting - Dallas
Strand Lighting Asia Limited
10911 Petal Street
Room 6-10,
Dallas, TX 75238
20/F Delta House 3 On Yiu Street
Tel: +1 214-647-7880
Shatin, N.T. Hong Kong
Fax: +1 214-647-8030
Tel: + 852 2757 3033
Fax: + 852 2757 1767
Strand Lighting - New York
Strand Lighting - Europe
267 5th Ave, 4th Floor
Marssteden 152
New York, NY 10016
Enschede 7547 TD
Tel: +1 212-213-8219
The Netherlands
Fax: +1 212-532-2593
Tel: +31 53 4500424
Fax: +31 53 4500425
LEKO LITE Luminaire User's & Installation Guide
Beam Shutters
(4 Each)
Front View
Figure 6: Beam Shutters
See Detail A
Detail A
Gobo Access Panel
Retaining Knobs
(2 Each)
Gobo
Area
Gobo Holder
Figure 7: Gobo Holder & Access Panel
Strand Selecon - Auckland
19-21 Kawana Street
Northcote, Auckland 0627
New Zealand
Tel: +64 9 481 0100
Fax: +64 9 481 0101
For service and support, please contact your
Authorized Strand Lighting Dealer or the nearest
Strand Lighting office. For the office or dealer
near you, please visit www.strandlighting.com.
User's & Installation Guide
For use with the following models:
o
o
11430C, 15
to 32
Variable Beam Angle LEKO LITE Luminaire
o
o
11440C, 23
to 50
Variable Beam Angle LEKO LITE Luminaire
o
11500C, 5
Fixed Beam Angle LEKO LITE Luminaire
o
11510C, 10
Fixed Beam Angle LEKO LITE Luminaire
o
11520C, 19
Fixed Beam Angle LEKO LITE Luminaire
o
11530C, 26
Fixed Beam Angle LEKO LITE Luminaire
o
11540C, 36
Fixed Beam Angle LEKO LITE Luminaire
o
11550C, 50
Fixed Beam Angle LEKO LITE Luminaire
IMPORTANT! Retain these instructions for future reference. DO NOT DISCARD!
Manual Number: 02.8101.0001 A

Advertisement

loading

Summary of Contents for Philips Leko Lite 11430C

  • Page 1 LEKO LITE Luminaire User’s & Installation Guide Beam Shutter Operation CAUTION: When adjusting the luminaire’s beam shutter, it is important to wear protective gloves. The luminaire produces extreme heat and all surfaces could cause serious burns if touched. Each LEKO LITE Luminaire is equipped with four independent shutters (as shown in Figure 6) to block or shape light as desired.
  • Page 2 LEKO LITE Luminaire. © 2010, Philips Group. All rights reserved. The material in this manual is for information purposes only and is subject to change without notice. Strand Lighting assumes no responsibility for any errors or omissions, which may appear in this manual. Informa- tion contained in this document may not be duplicated in full or in part by any person without prior written approval of Strand Lighting.
  • Page 3 LEKO LITE Luminaire User’s & Installation Guide Focus and Beam Angle Adjustments Lamp Installation Lamping and relamping is quick and easy. All lamping should be done with the power removed from the luminaire. Great CAUTION: When adjusting the luminaire’s focus or beam distribution, it is important to wear protective gloves. The care should be used when handling the lamp.
  • Page 4 LEKO LITE Luminaire User’s & Installation Guide Accessories / Installation / Mounting Focus and Beam Angle Adjustments Accessories CAUTION: When adjusting the luminaire’s focus or beam distribution, it is important to wear protective gloves. The luminaire produces extreme heat and all surfaces could cause serious burns if touched. The following LEKO LITE Luminaire accessories are available through your Authorized Strand Lighting Dealer.