Table of Contents
Advertisement
Item
Enable HTTP Server
Port
Quality and Frame Rate Setup for Network Transmission
No.
Quality
FPS
Auto
This video streaming is used for network transmission; setting is LQ (low quality). Under a low bandwidth
capacity, this stream can send out small picture and keep a good video quality and smooth display rate. If
the bandwidth is large enough, it can be adjusted to HQ (high quality). Thus, the network streaming will be
switched to the condition which this DVR is recording. Therefore, a larger video image can be sent to
remote site.
5.7.3 DDNS Setup
Item
Enable DDNS
DDNS Server
Host Server
User Name
Password
Check to enable HTTP server. Users can remotely access into the DVR
over the network if the HTTP function is activated.
Enter a valid port value from 1 up to 65535. The default value is 80.
Check to activate the transmission of each camera.
Choose from Below Basic / Basic/ Normal/ High/ Highest.
Choose recording frame rate (1~30FPS).
The maximum recording frames available by the average distribution of
each channel (totally 60FPS).
Check/ Uncheck to Enable/ Disable DDNS function.
Enter the registered SMTP Server:
DYNDNS.ORG, NO-IP.ORG, CUSTOM.COM
Enter the registered SMTP Server.
Enter user name.
Enter password.
34
Description
Description
Advertisement
Table of Contents
