CORDED POwER UNIT & DRILL ATTAChMENT INSTRUCTION MANUAL Catalog Number BDEDMT Thank you for choosing Black & Decker! Go to www.BlackandDecker.com/NewOwner to register your new product. PLEASE READ BEfORE RETURNING ThIS PRODUCT fOR ANy REASON: If you have a question or experience a problem with your Black & Decker purchase, go to hTTP://www.BLACkANDDECkER.COM/INSTANTANSwERS If you can’t find the answer or do not have access to the Internet, call 1-800-544-6986 from 8 a.m.
SAfETy GUIDELINES - DEfINITIONS It is important for you to read and understand this manual. The information it contains relates to protecting YOUR SAFETY and PREVENTING PROBLEMS. The symbols below are used to help you recognize this information. DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
d) Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left attached to a rotating part of the power tool may result in personal injury. e) Do not overreach. keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations.
wARNING: ALwAyS use safety glasses. Everyday eye glasses are NOT safety glasses. Also use face or dust mask if cutting operation is dusty. ALwAyS wEAR CERTIfIED SAfETy EQUIPMENT: • ANSI Z87.1 eye protection (CAN/CPA Z94.3), • ANSI S12.6 (S3.19) hearing protection, • NOSH/OSHA respiratory protection. SyMBOLS The label on your tool may include the following symbols. The symbols and their definitions are as follows: V ....volts...
SAVE ThESE INSTRUCTIONS Safety warnings and Instructions wARNING: Shock hazard. when drilling or driving into walls, floors or wherever live electrical wires may be encountered, DO NOT TOUCh ANy METAL PARTS Of ThE TOOL! hold the tool only by the plastic handle(s) / housing to prevent shock. •...
• To remove an attachment, depress the release button (3) and take the attachment off the tool. • To fit an attachment, line it up with the tool as shown and push it onto the Power Unit until it snaps into place and an audible click is heard. • Ensure attachment is securely attached by gently pulling it away from the Power Unit. NOTE: Only use attachments that are specifically designed for and compatible with the Power Unit. NOTE: Refer to individual attachment instruction manuals for specific safety warnings and operating instructions before oper- ating attachments with the Power Unit.
ON-BOARD BIT STORAGE A bit storage slot (4) is built-in to the handle of the Power Unit for easy bit storage and access. DRILLING • Use sharp drill bits only. • Support and secure work properly, as instructed in the Safety Instructions. • Use appropriate and required safety equipment, as instructed in the Safety Instructions. • Secure and maintain work area, as instructed in the Safety Instructions. • Run the drill very slowly, using light pressure, until the hole is started enough to keep the drill bit from slipping out of it. • Apply pressure in a straight line with the bit. Use enough pressure to keep the bit biting but not so much as to stall the motor or deflect the bit. • hold the drill firmly with two hands to control its twisting action. • DO NOT CLICK THE TRIGGER OF A STALLED DRILL OFF AND ON IN AN ATTEMPT TO START IT.
ACCESSORIES wARNING: The use of any accessory not recommended for use with this tool could be hazardous. Recommended accessories for use with your tool are available from your local dealer or authorized service center. If you need assistance regarding accessories, please call: 1-800-544-6986. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.