Power Control - Sharp Aquos LC-57D90U Operation Manual

Basic adjustment settings
Power control setting allows you to save energy.
No signal off
When set to "Enable", the power will automatically shut
down if there is no signal for 15 minutes.
Power control setting allows you to save energy.
Power management
When set, the power will automatically shut down.
1
Press MENU and the MENU screen displays.
Repeat steps 1 and 2 in No signal off.
2.·:
Press
~/~
to select "Power Control".
Press
./T
to select "Power Management",
and then press ENTER.
• No power management
• Factory preset value.
• If no signal inputs for 8 minutes, the power
shuts down.
• Even if you start using the PC and the signal
inputs again, the TV stays off.
• The TV turns on again by pressing TV
POWER on the remote control unit (See
page 15).
• Pressing POWER on the TV will have the
same result.
Press
./T
to select "Mode1" or "Mode2",
and then press ENTER.
Mode1
Off
• Five minutes before the power shuts down, the
remaining time displays every minute.
Press
./T
to select "No Signal Off", and
then press ENTER.
Press MENU to exit.
Press
~/~
to select "Enable", and then
press ENTER.
_::
..
• "Disable" is the factory preset value.
• When a TV program finishes, this function may not operate.
No operation off
When set to "Enable", the power will automatically shut
down if there is no operation for 3 hours.
Repeat steps 1 and 2 in No signal off.
Mode2
• If no signal inputs for 8 seconds, the TV
enters standby mode.
• When you start using the PC and the signal
inputs again, the TV turns on.
Press MENU to exit.
2
Press
./T
to select "No Operation Off", and
then press ENTER.
Press
~/~
to select "Enable", and then
press ENTER.
• Five minutes before the power shuts down, the
remaining time displays every minute.
Press MENU to exit.
• When using a digital PC and setting "Mode2" in Power
management, the power may not turn back on
automatically even if the signal inputs again.
• If you turn off the power by disconnecting AC cord when
setting "Mode2" in power management, the TV may not
function properly after turning the power on again. In such
case, press TV POWER on the remote control unit.
• Pressing POWER on the TV will have the same result.
• "Disable" is the factory preset value.
@-30