LCD Color TV Wall-Mount Bracket Téléviseur couleur LCD et le support de AN-65AG1 montage au mur Wandhalter für LCD-Farbfernsehgerät Ménsula de montaje el TV color de cristal líquido en la pared OPERATION MANUAL MODE D’EMPLOI BEDIENUNGSANLEITUNG MANUAL DE MANEJO • The wall bracket mounting screws are not in- cluded with the product, so please separately purchase off-the-shelf screws.
• Thank you for purchasing a SHARP product. Before using the product, please be sure to read this operation manual carefully. In particular, be sure to read the section “To Ensure Safe and Correct Use.” After reading the manual, keep it in a convenient location where it can be accessed at any time.
The customer the LCD color TV and the wall-mount bracket. should not attempt to install the TV. Sharp shall • Be sure to use two or more people to conduct the not be responsible for improper installation or work.
Determine the TV installation location after taking into consideration the viewing posture, line of sight, and the visual and aural ranges. • Sharp shall bear no responsibility for damages, etc., caused by the LCD color TV falling due Caution to insufficient installation strength or improper installation.
Wall-Mount Bracket Installation Determine the location where the base bracket will be Included part installed. (1) Use tape or other means to mark the measured positions on the wall where the display will be installed. The center of the “X” drawn from the four corners of the square marks the center of the panel.
Installing the wall-mount bracket (For Model 65 inch Separate Type) • Be sure to use at least two people to perform the wall-mount bracket installation work for the LCD color TV. Caution • The installation work must be conducted while the LCD color TV is standing upright, so be careful that it does not fall over.
Installing the wall-mount bracket (Continued) Connect the system cables and power cord to the terminals on the back of the LCD color TV. System cables Power cord Use the cable holder at the center of the back of the LCD color TV and the cable holders holding the speaker cables to connect the system cables.
Set the angle of the wall-mount bracket • Please perform this work before mounting the LCD color TV on the wall. Caution • When setting the angle of the wall-mount bracket, be careful not to pinch your fingers, etc. Remove the perpendicular positioning screws from the wall-mount bracket (2 screws each on the left and right sides).
Remove the stands • Be sure to use at least 3 people for the work from this point onward. Caution • Be very careful when holding the LCD color TV at a slant or when lifting it up. Lift up the LCD color TV and remove the stand. While the stand is being held down, lift up the LCD color TV to remove it from the stand.
Installing the LCD color TV on the wall • Be sure to use at least 4 people when installing the LCD color TV to the base bracket. Caution • Be sure to perform Steps 1 and 2 below. Only performing Step 1 could result in the display falling and injuring someone.
Printed in Japan Imprimé au Japon Printed on 100% post-consumer recycled paper. DSC1 Imprimé sur 100% de papier recyclé. TINSE1082MPZZ (1)