Audio Control; Volume - Kenwood KDC-X959 Instruction Manual

3
Select the Audio item for adjustment
Press the [FM] or [AM] button.
Each time the button is pressed the items that can be adjusted
switch as shown below.
4
Adjust the Audio item
Press the [4] or [¢] button.
Adjustment Item Display
Bass Center "Bass FRQ"
Frequency
Bass level "Bass"
Bass Q Factor "Bass Q"
Bass Extend "Bass EXT"
Middle Center "Middle FRQ"
Frequency
Middle level "Middle"
Middle Q Factor "Middle Q"
Treble Center "Treble FRQ"
Frequency
Treble level "Treble"
Balance "Balance"
Fader "Fader"
Non-Fading level* "NF Level"
Front High Pass Filter "HPF Front"
Rear High Pass Filter "HPF Rear"
Non-Fading "LPF NF"
Low Pass Filter*
Non-Fading Phase* "NF Phase"
Volume offset "Volume Offset"–8 — ±0
Range
60/70/80/100 or 150 (Hz)
–8 — +8
1.00/1.25/1.50/2.00
ON/OFF
0.5/1.0/1.5/2.0 (kHz)
–8 — +8
1.0/2.0
10.0/12.5/15.0/17.5 (kHz)
–8 — +8
Left 15 — Right 15
Rear 15 — Front 15
–15 — +15
Through/40/60/80/100/120/
150/180/220 (Hz)
Through/40/60/80/100/120/
150/180/220 (Hz)
50/80/120/Through (Hz)
Normal (0°)/Reverse (180°)
— 11 —
• According to the Bass Q Factor setting value, the frequencies that
can be set in Bass Center Frequency change as shown below.
Bass Q Factor
1.00/1.25/1.50
2.00
• When the bass extend is set to ON, low frequency response is
extended by 20%.
• Volume offset: Each source's volume can be set as a difference
from the basic volume.
*:
• This mode is available only when <Non-fading Output> (page
19) is ON.
5
Exit Audio Control mode
Press the [AUD] button.
Bass Center Frequency
60/70/80/100
60/70/80/150