Installation - Bauknecht WA 43510 Instructions For Use Manual

Installation

Remove the transit bolts
1. Slacken the four bolts with
the spanner supplied.
2. Remove by hand.
3. Grip the bolt and remove it
through the large aperture.
4. Seal the resulting holes
using the plastic caps
supplied; Insert the caps in
the direction of the arrow in
the large aperture and insert
them in the narrow slot until
they click into place.
5. Retain transit bolts.
Secure the washing
machine before
transporting it:
1. Pry off the plastic caps with a
screwdriver, slide them in
the opposite direction to the
arrow and remove.
2. Refit the transit bolts in
reverse order.
Adjust the feet
Small unevennesses in the floor can
be compensated for by screwing
the four appliance feet up or down
(never use pieces of wood,
cardboard or similar material);
1. Loosen the locknut using the
wrench provided.
2. Adjust the height of the foot
by hand.
3. Tighten the locknut
anticlockwise towards the
washing machine casing.
If the appliance is to be installed
on a wooden floor, place it on a
sheet of plywood at least
60x60 cm in size and 3 cm thick.
Screw the plywood sheet firmly
to the floor.
25