Before Using The Washing Machine - Bauknecht WA 43510 Instructions For Use Manual

Before using the washing machine

1.Remove the packaging and
check
• After unpacking, make sure
that the washing machine is
undamaged. If in doubt, do
not use the washing machine.
Contact After-Sales Service or
your local retailer.
• Check that the accessories and
supplied parts are all present.
• Keep the packaging materials
(plastic bags, polystyrene
parts, etc.) out of the reach of
children; they can constitute a
possible source of danger.
2.Remove the transit bolts
• The washing machine is fitted
with a transport bolts to avoid
any possible damage to the
interior during transport.
Before using the washing
machine, the transport bolts
must be removed (see
"Installation/Remove the
transit bolts").
3.Install the washing
machine
• Remove the protective foil
from the control panel.
• Move the appliance without
lifting it by the worktop.
• Install the appliance on a solid
and level floor surface,
preferably in a corner of the
room.
• Make sure that all feet are
resting correctly on the floor
and that the washing machine
is perfectly level and stable
(use a spirit level - see
Installation/Adjusting the
Feet).
4.Water inlet
• Connect the water supply inlet
hose in accordance with the
regulations of your local water
company (see "Installation/
Connect the water inlet
hose").
• Water inlet: Cold water only
• Tap: 3/4 threaded
hose
connection
• Water
pressure 100-1000 kPa
(flow
pressure): (1-10 bar).
5.Drain hose
• Connect the drain hose to the
siphon or hook it over the edge
of a sink by means of the "U"
bend (see "Installation/
Connect the water drain
hose").
• If the washing machine is
connected to a built-in
pumping out system, ensure
that the latter is equipped with
a vent to avoid simultaneous
loading and draining of water
(siphoning effect).
6.Electrical connections
• Electrical connections must be
carried out by a qualified
technician in compliance with
the manufacturer's
instructions and local safety
regulations.
• Data concerning voltage,
consumption and fuses are
located on the inside of the
appliance door.
• The appliance must be
connected to the mains
exclusively by means of a socket
with an earth connection in
accordance with established
regulations. The washing
machine must be earthed by
law. The manufacturer declines
all responsibility for injury to
persons or pets, or damage to
property caused by non-
compliance with the above-
mentioned regulations.
• Do not use extension leads or
multi sockets.
• Before any maintenance on
the washing machine
disconnect it from the mains
supply.
• Access to the mains plug or to
disconnection from mains
supply via a double-pole switch
must be ensured at all times
following the installation.
• Do not operate the washing
machine if it has been
damaged during transport.
Inform the After-Sales Service.
• Mains cable replacement is
only to be carried out by After-
Sales Service.
• The washing machine must
only be used in the household
for the prescribed uses.
Minimum housing
dimensions:
Width: 600 mm
Height: 825 mm
Depth: 600 mm
23