Instrument Panel; Hourmeter - Walker T25i Operator's Manual

Operating Instructions

Instrument Panel

This illustration shows the configuration of the
switches and indicators located on the instrument
panel.

Hourmeter

Voltmeter
Light Switch
(Optional)
Hourmeter
The hourmeter, which is located on the instrument
panel, displays operating time accumulated while
the ignition switch is in the RUN position.
The hourmeter provides maintenance reminders af-
ter certain hours of operation. The hourmeter screen
will start flashing the reminder one hour prior to the
recommended interval and will continue until one
hour after the recommended interval (two hours).
The hourmeter does not have a manual reset
function.
Oil Pressure
Warning Light
7 AMP
Circuit Breaker
Instrument Panel
Over Temperature
Warning Light
Procedure Interval*
Oil Change
4-6 Hours
(Break-In)**
Lubricate
and Check 24-26 Hours
Levels
49-51 Hours***
Oil Change
* These intervals reflect the actual time that the
reminder will flash (one hour prior to and one
hour after the recommended interval).
** This reminder is only used one time.
*** In normal operating conditions, oil changes in
100-hour intervals are acceptable. Walker and
the engine manufacturers recommend engine
oil changes every 50 hours in extremely dirty or
dusty conditions or for units with less than 100
hours annual use.
Ignition
Switch
Engine
Service
Light
Warning
Horn
Reminder
C
H OIL
G
LUBE
C
H OIL
G
31