Connecting With Rf Cable (Aerial Cable); Auto-Setup With Rf Cable (Aerial Cable) - Panasonic DMR-ES20DEB Operating Instructions Manual

Connecting with RF cable (Aerial cable)

1
Aerial
RF cable /
Aerial cable
RF IN
Aerial input
RF OUT
RF OUT
Aerial output
2
RF cable /
Aerial cable
DVD Display
Auto-Setup
Auto-Setup in progress, please wait.
Suche Sender, bitte warten.
RETURN: to abort
RETURN: abbrechen
RETURN
Owner ID
PIN number
* * * *
Name
House No.
Postcode
RETURN
RETURN : leave
Clock
Time
:
0 00
No
0
9
Clock cannot be set automatically.
Please set the clock manually.
CHANGE
SELECT
ENTER: store RETURN: leave
ENTER
RETURN
Downloaded From Disc-Player.com Panasonic Manuals
14
DVD Recorder
VIDEO S VIDEO OUT
RF IN
L L
AV1 (TV)
Y P P R
B
AUDIO
OPTICAL
S VIDEO COMPONENT
R R
AV4 IN VIDEO OUT
(PROGRESSIVE/ DIGITAL AUDIO OUT
AV4 IN OUT
AV2 (EXT) INTERLACE)
(PCM/BITSTREAM)
A erial
input
3
AC mains lead

Auto-Setup with RF cable (Aerial cable)

Turn on your television set.
With the Standby/on switch turn on the DVD Recorder. Automatic tuning for all available
TV stations begins. Approximate duration is 5 minutes.
- While Auto-Setup is running the first digit of the DVD Recorder display will flash.
After a while it will stop flashing and the RF output channel number will be displayed.
Ch
35 4 - Select an unused channel pre-set on your TV and tune it to the RF output channel
number shown on the DVD Recorder display (or until you can clearly see the Auto-Setup
screen). Store the new RF output channel (refer to the instructions for your TV).
After Automatic tuning has finished, the Owner ID screen will appear.
In some cases, the RF output channel may interfere with the TV stations transmitted in
your area. This may prevent you from seeing the On-Screen Display clearly.
Please see page 15 for removing the interference before restarting Auto-Setup.
Owner ID
You can complete the Owner ID now or skip this step and do it later. To do it later, press the
RETURN button. Your DVD Recorder is now ready to use.
To set the Owner ID now, use
digit PIN number. Press , to correct the digit.
Make sure that you will remember the PIN number (make a note of it).
Press the ENTER button twice to confirm.
Enter the [Name], [House No] and [Postcode] in the same way, using
Press the ENTER button to confirm each entry.
Press the RETURN button to leave the Owner ID screen.
You will now see the TV picture. Your DVD Recorder is now ready to use.
Automatic Off
If the clock setting menu appears
Date
(Auto clock set was not possible due to a weak signal)
: . . 2005
00 1 1
Press
Note: A wrong date or time will influence the programmed recording of TV programmes
(don't forget to change summer time and winter time).
Follow the steps below.
Disconnect the power of all units.
1
AC IN
2
AC IN~
3
3
AC mains lead
Follow the steps for Auto-Setup on page 14.
TV
AC mains socket
and press the Numeric buttons or
to set the correct time and date and press ENTER to finish this setting.
Connect aerial to the RF IN (Aerial input)
connector of the DVD Recorder.
Connect the DVD Recorder´s RF OUT (Aerial
output) to the TV set's Aerial in connector.
Connect DVD Recorder and TV set to the AC
mains socket.
(Automatic tuning)
43
to enter a four-
.