Connecting With Rf Cable - Panasonic DMR-ES30VEB Quick Start Manual

Connecting with RF cable

S
=Extra equipment for the connection shown:
RF cable (Aerial cable)
S VIDEO
VIDEO
L
AUDIO
R
AC IN~
DVD OUT
AC IN~
4
AC mains lead
1
AC mains socket
DVD Display
Auto-Setup
Ch
35 4
Auto-Setup in progress, please wait.
Suche Sender, bitte warten.
RETURN: to abort
RETURN: abbrechen
RETURN
Owner ID
PIN number
* * * *
Name
* * * * * * * * * * * * * *
House No.
* * * * * * * * * * *
Postcode
* * * * * * * * * * *
RETURN
RETURN : leave
Clock
Automatic Off
Time Date
0 : : . . 2005
00 00 1 1
No
0 9
Clock cannot be set automatically.
Please set the clock manually.
CHANGE
SELECT
ENTER: store RETURN: leave
ENTER
RETURN
Aerial
DVD Recorder
Y
P
B
OPTICAL
P
R
AV2 (EXT) AV1 (TV)
Aerial
RF cable /
Aerial cable
TV
4
AC mains lead
Auto-Setup with RF cable (Aerial cable)
Turn on your television set.
With the Stand-by/on switch turn on the DVD Recorder. Automatic tuning for
all available TV stations begins. Approximate duration is 5 minutes.
After Automatic tuning has finished, press RETURN. The Owner ID screen will
appear.
- While Auto-Setup is running the first digit of the DVD Recorder display will
flash. After a while it will stop flashing and the RF output channel number will
be displayed.
- Select an unused channel pre-set on your TV and tune it to the RF output
channel number shown on the DVD Recorder display (or until you can clearly
see the Auto Setup screen). Store the new video playback channel (refer to
the instructions for your TV).
In some cases, the RF output channel may interfere with the TV stations transmitted in
your area. This may prevent you from seeing the On-Screen Display clearly. Please
see page 6 for removing the interference before restarting Auto-Setup (page 72 of
Operating Instructions).
Owner ID
You can complete the Owner ID now or skip this step and do it later. To do it
later, press the RETURN button. Your DVD Recorder is now ready to use.
To set the Owner ID now, use
enter a four-digit PIN number. Press , to correct the digit.
Make sure that you will remember the PIN number (make a note of it).
Press the ENTER button twice to confirm.
Enter the [Name], [House No] and [Postcode] in the same way, using
Press the ENTER button to confirm each entry.
Press the RETURN button to leave the Owner ID screen.
You will now see the TV picture. Your DVD Recorder is now ready to use.
If the clock setting menu appears
(Auto clock set was not possible due to a weak signal)
Press
setting.
Mind that a wrong date or time will influence the programmed recording of TV
programmes (don't forget to change summer time and winter time).
2
Aerial
RF IN
input
S
RF cable /
Aerial cable
RF IN
RF OUT
RF OUT
output
3
Aerial input
and press the Numeric buttons or
to set the correct time and date and press ENTER to finish this
- 5 -
You can connect the DVD Recorder to
your TV set by using a RF cable.
Follow the steps described below.
1
Ensure TV Power is disconnected
from AC mains socket.
2
Connect aerial to the RF IN (Aerial
input) connector of the DVD
Recorder.
3
Connect the DVD Recorder´s RF
OUT (Aerial output) to the TV set's
Aerial in connector.
4
Connect DVD Recorder and TV set
to the AC mains socket.
Follow the steps for Auto-Setup on
this page.
(Automatic tuning)
to
.