Connecting With Rf Cable (Aerial Cable) - Panasonic Diga DMR-EH80VEB Quick Start Manual

Connecting with RF cable (Aerial cable)

DVD Recorder
HDD/DVD OUT
TV
3
AC mains lead
DVD Display
Auto-Setup
Ch
35 4
Auto-Setup in progress, please wait.
Suche Sender, bitte warten.
RETURN: to abort
RETURN: abbrechen
RETURN
Owner ID
PIN number
* * * *
Name
House No.
Postcode
RETURN
RETURN : leave
Clock
Automatic Off
Time Date
: : . . 2005
0 00 00 1 1
No
0 9
Clock cannot be set automatically.
Please set the clock manually.
CHANGE
SELECT
ENTER: store RETURN: leave
ENTER
RETURN
1
3 AC mains lead
RF IN
Aerial input
AC IN~
AV1 21-pin
RF OUT
Scart socket
Aerial output
RF cable
Aerial
input
Auto-Setup with RF cable (Aerial cable)
Turn on your television set.
With the Standby/on switch turn on the DVD Recorder. Automatic tuning for all
available TV stations begins. Approximate duration is 5 minutes.
- While Auto-Setup is running, the first digit of the DVD Recorder display will flash. After
a while it will stop flashing and the RF output channel number will be displayed.
- Select an unused channel pre-set on your TV and tune it to the RF output channel
number shown on the DVD Recorder display (or until you can clearly see the Auto-
Setup screen). Store the new RF output channel (refer to the instructions for your TV).
After Automatic tuning has finished, the Owner ID screen will appear.
In some cases, the RF output channel may interfere with the TV stations transmitted in
your area. This may prevent you from seeing the On-Screen Display clearly. Please
see page 24 of Operating Instructions
Auto-Setup (page 97
Owner ID
You can complete the Owner ID now or skip this step and do it later. To do it later, press
the RETURN button. Your DVD Recorder is now ready to use.
To set the Owner ID now, use
four-digit PIN number. Press , to correct the digit.
Be sure to remember the PIN number (write it down).
Press the ENTER button twice to confirm.
Enter the [Name], [House No] and [Postcode] in the same way, using
Press the ENTER button to confirm each entry.
Press the RETURN button to leave the Owner ID screen.
You will now see the TV picture. Your DVD Recorder is now ready to use.
If the clock setting menu appears
(Auto clock set was not possible due to a weak signal)
Press to set the correct time and date and press ENTER to finish this setting.
Mind that a wrong date or time will influence the programmed recording of TV
programmes (don't forget to change summer time and winter time).
Aerial
Since optimal picture quality cannot be achieved, the
connection with the RF cable is not recommended.
You can connect the DVD Recorder to your
TV set by using a RF cable (Aerial cable).
E
Follow the steps below.
Aerial
infeed line
Disconnect the power from all units.
1
Connect aerial to the RF IN (Aerial
input) connector of the DVD Recorder.
2
Connect the DVD Recorder´s RF OUT
(Aerial output) to the TV set's Aerial in
connector.
2
3
Connect DVD Recorder and TV set to
the AC mains socket.
Follow the steps for Auto-Setup on this
page.
E
= Extra equipment for the connection shown:
for removing the interference before restarting
of Operating Instructions
and press the Numeric buttons or
- 5 -
RF cable (aerial cable)
(Automatic tuning)
).
to enter a
.