Setting The Time Code - Canon EOS 5D Mark III Instruction Manual

Setting the Time Code

3
Count Up
[Rec run] : The time code counts up only while you are shooting a
movie. The time code will be continuous across
sequential movie files.
[Free run] : The time code counts up whether you are shooting or not.
Start Time Setting
You can set the time code's start time.
[Manual input setting]: You can freely set the hour, minute, second,
[Reset]
[Set to camera time] : Sets hours, minutes, and seconds to match
If [Free run] is set and you change the time, zone, or daylight saving time
(p.36), the time code will be affected.
The time code is a time reference
recorded automatically to synchronize
the video and audio during movie
shooting. It is recorded at all times in the
following units: hours, minutes, seconds,
and frames. It is mainly used during
movie editing.
Set the time code with [z5: Time
code]. In the <A> mode, this function
is displayed in [z3].
and frames.
: The time set with [Manual input setting] and
[Set to camera time] is reset to 00:00:00:00.
the camera's internal clock. "Frames" will be
set to 00.
239