Armrest Angle Adjustment; Armrest Height Adjustment - Pride Mobility Jet1 Owner's Manual

V . C O M F O R T

ARMREST ANGLE ADJUSTMENT

You can adjust the armrest angle to fit your specific
needs. See figure 15.
To change the armrest angle:
1. Lift the armrest straight up so that it is perpendicu-
lar to the floor.
2. Use a 1/2-in. wrench to loosen the jam nut. See
figure 15.
3. Use a 1/2-in. wrench to loosen the adjusting screw.
4. Turn the screw clockwise to lower the front of the
armrest, or turn the screw counterclockwise to raise
the front of the armrest.
5. Lock the adjusting screw into place by tightening
the jam nut.

ARMREST HEIGHT ADJUSTMENT

(OPTIONAL)
Your Jet 1 may be equipped with height-adjustable
armrests.
To change the armrest height:
Loosen the knob located underneath the armrest, raise
bar to set height, and re-tighten knob.
JOYSTICK EXTENSION ADJUSTMENT
The joystick control can easily slide out away from the
armrest, or in toward the armrest. See figure 16.
To extend the joystick:
1. Use a 5 mm hex key to loosen the setscrew.
2. Slide the joystick mounting bracket into or out of
the armrest to the desired position.
3. Tighten the setscrew by turning the hex key clockwise.
Jet 1
A D J U S T M E N T S
TURN THIS
SCREW TO
CHANGE
ARMREST
ANGLE
JAM NUT
LOCKS
ADJUSTING
SCREW IN
PLACE
Figure 15. Armrest Angle Adjustment
LOOSEN
THIS
SETSCREW
TO ADJUST
JOYSTICK
Figure 16. Joystick Extension
17