Disconnecting Theipod; Recording The Program Source; (Recording The <Sourc:e Currel1Tlybeingmonitored); Aboutthememoryfunetiolls - Denon DRA-297 Operating Instructions Manual

Am-fm stereo receiver
Hide thumbs Also See for DRA-297:
Table of Contents

Advertisement

Operation
Use this procedure to view photo and video data stored on the iPod
on a monitor.
• To output photo or video data recorded on the iPod to the monitor,
the iPod's "TV Out" setting (under "Video Settings") must be set to
"ON".
For details, refer to the iPod's operating instructions.
*
The iPod can be disconnected after switching toafunction other
than the one to which the iPod input is assigned.
Recording the program source (recording the
source currently being monitored)
• The AUDIO IN's signal selected
with INPUT SELECTOR are output to
the CD-RffAPE and VCR AUDIO OUT terminals.
o
Simultaneous recording
The signals of the source selected with INPUT SELECTOR are output
simultaneously to the CD-RffAPE and VCR REC OUT terminals. If a
total of two tape and/or video decks are connected and set to the
recording mode, the same source can be recorded simultaneously on
every decks.
18
ENGLISH
ENGLISH
Operation
About the memory functions
o
Last function memory
The various settings set when the DRA-297's power is switched to
standby are stored in the memory. When the power is turned back on,
the settings made when the power was switched to standby are
recalled.
o
Backup memory
The various settings are stored in the memory for about 1 week, even
when the power is turned off or the power cord is unplugged.
Initialization of the microprocessor
If the indication on the display is not normal or if the operation of the
unit is not correct, then the microprocessor should be reset by the
following procedure.
1.
Switm
off the
lIDitusiog<POWEB>.
3Check
that
the entire
eli
ay
is ftasbiDg
at l-second
intervals and
release the buttons.
• The microprocessor
will be initialized.
• If step 3 does not work, start over from step 1.
• If the microprocessor has been reset, all the button settings are
reset to the default values (the values set upon shipment from the
factory).

Advertisement

Table of Contents
loading

Table of Contents