Pride Luna Victory Owner's Manual page 38

V I I I . B A S I C T R O U B L E S H O O T I N G
DIAGNOSTIC FAULT CODES - LUNA VICTORY E
The diagnostic fault codes for your scooter are designed to help you perform basic troubleshooting quickly
and easily. A diagnostic fault code and error message will be displayed in the event one of the conditions
listed below develops.
NOTE: Your scooter will not run unless the fault code condition is resolved and the scooter has been
turned off, then turned back on.
FAULT CODE
(1)
(2)
(3)
(4)
(5)
38
CONDITION
Battery charge is low.
Battery charge is too low.
The scooter's battery voltage is too
high to operate the scooter, or the
charger is still connected to the off-
board charger port.
Current limit time out.
The manual freewheel lever is in the
(forward) freewheel position.
(6) Throttle control lever not at center
position at start up.
Speed pot error.
(7)
(8) Motor volts error.
(9) Other internal errors.
www.pridemobility.com
SOLUTION
Charge batteries as soon as possible.
If fault continues, contact your
authorized Pride Provider to have
batteries load tested.
Charge batteries.
Unplug charger and/or turn key off,
then back on again.
Turn the scooter off for a few min-
utes, then turn your scooter back on.
Remove the key from the key
switch, then push the manual free-
wheel lever to the drive (backward)
position and restart your scooter.
Return the throttle control lever to
center position, turn scooter off then
back on.
Call your authorized Pride Provider
for assistance.
Call your authorized Pride Provider
for assistance.
Call your authorized Pride Provider
for assistance.
Luna Victory Series