Stealth Cam STC-G42NG Instruction Manual page 12

CAMERA P ROGRAMMING -­‐ C USTOM ( CONT)
TIME FORMAT – 12 HOUR (default): This setting is used to tell camera if the time
Ø
programmed and displayed on the Info Bar should be in the basic 12 hour (AM/PM) format
or t he 2 4 h our ( military) f ormat. W ith t his o ption b linking, p ressing t he U P o r D OWN a rrow
buttons will cause the camera to cycle between the two options. NOTE: Should the format
be changed to 24 hour, the previous SETUP TIME will now be adjusted as such and remove
the A M/PM p art o f t he t ime.
MODE – T his s etting i s u sed t o t ell t he c amera h ow i t s hould t ake i ts i mages. T he c amera i s
Ø
equipped w ith T RIAD T echnology, a llowing f or 3 d ifferent o ptions t o b e s elected b y t he u ser.
With this option blinking, use the UP or DOWN arrow key to move between the options of:
PIR PHOTO, PIR VIDEO, or TL. Based upon the selection chosen the menus for the camera
will c hange.
o PIR PHOTO (default): In this mode the camera will take a designated amount of picture with a
designated t ime o ut w hen t he c amera s enses a ctivity i n f ront o f t he u nit. T his m ode i s a vailable f or
both d ay a nd n ight a ctivities.
§ PHOTO RES – 5.0 MP ( default): T his s etting i s u sed t o d etermine t he M egapixel r esolution o f
each image taken by the camera. With this option blinking, use the UP or DOWN arrow key
to move between the options of: 10MP, 8MP, 4MP, 2MP or 0.5MP. The higher the
resolution o f a n i mage t he m ore s pace t he f ile w ill t ake o n t he S D m emory c ard.
PIR DELAY – 00min 05sec ( default): T his s etting i s u sed t o d etermine t he l ength o f t he t ime
that t he c amera w ill w ait b efore i t r einitializes i ts P IR s ensor f or t he n ext a ctivation. W ith t he
TL mode this setting is only active if TL Delay is set to 1 min or greater. This setting can be
changed between the numbers of 00min 05sec to 59min 59sec. With this option blinking,
use of the UP and DOWN arrows will allow the minutes setting to be changed from 00 to
59. Once this setting is on the appropriate minutes, press the RIGHT arrow key to move to
the seconds setting and it will start to blink. Use of the UP and Down arrows will allow the
seconds s etting t o b e c hanged f rom 0 0 t o 5 9 ( 05 t o 5 9 i f m inutes = 0 0).
www.stealthcam.com P age
877-­‐269-­‐8490
12