Controller Setups For Cardioid Use; Replacing The Fuses - KLING & FREITAG NOMOS XLC User Manual

User's manual

6.2

Controller￿setups￿for￿cardioid￿use
The following cardioid or hypercardioid setups are available in the K&F CD 44. All setups with a cutoff
frequency other than 60Hz have a cutoff frequency of 100Hz.
Operation￿Mode
'Cardioid'
'Hypercardioid'
'Infrabass Cardioid'
'Infrabass Hypercardioid'
7. NOMOS￿XLC￿combined￿with￿other￿K&F￿tops.
The NOMOS XLC can be combined with K&F top speakers using the controller K&F CD 44.
• To do so, select the desired LS blocks for the top in the Controller CD 44, and combine these
with the desired LS block for the NOMOS XLC.
• Then activate the 'Combi Mode' by switching on Filter B for the NOMOS XLC channel.
When￿combining￿with￿SEQUENZA￿10￿N/W￿tops,￿Filter￿B￿(Combi￿Mode)￿may￿not￿be￿switched￿on!
In the CD 44 Hardware Manual, you will find a detailed description about connecting the SEQUENZA 10
speakers and the settings necessary on the System Controller CD 44. NOMOS XLC
8. Fuse￿in￿the￿NOMOS￿XLC
To increase the operating safety of the NOMOS XLC, the subwoofers are equipped with fuses at the
signal input. These fuses reduce the risk of consequential damage resulting from a short circuit (i.e.
charred cables / connectors / fire damage).
8.1 Replacing￿the￿Fuses
The fuse holder is behind the rear chassis.
Replace the fuse with the following original fuse only:
Bussmann￿S￿506-8A
KLING & FREITAG GMBH © 2009
Chassis
front
rear
front
rear
front
rear
Front
Rear
Revision 2.0
K&F NOMOS XLC
Controller￿Setup
NOMXLC C-F
NOMXLC C-R
NOMXLC HC-F
NOMXLC HC-R
NOMXLC C-F60Hz
NOMXLC C-R60Hz
NOMXLC HC-F60Hz
NOMXLC HC-R60Hz
Page 10 of 18